Home › Warning lights › Parking brake light
Red: serious, act now

Parking brake light

Also called: Handbrake light, Emergency brake light, Park brake reminder, Red P light, BRAKE light

How urgent? Get it checked soon

What it means

Your parking brake is applied, or the car thinks it is. On most cars the same red lamp also warns about the brake system itself, so if it stays on with the brake fully released, treat it as a brake problem.

It sits in the main cluster right in front of you, usually in the row of red lights near the temperature and oil lamps. Most cars show a red circle with a P inside and two small curved brackets on each side. Some use an exclamation mark in the circle instead, and some older cars just light the red word BRAKE. On many makes it is the very same lamp used for brake system faults.

Can I keep driving?

Release the parking brake and the light should go out within a second or two. If it goes out, you are fine to drive. If it stays on with the brake released, or the pedal feels soft or sinks toward the floor, stop driving and have the brakes checked or the car towed.

If it's flashing or blinking: On some cars with a button-operated parking brake, the red light blinks instead of staying steady. A blinking light means the brake has not finished clamping or has not fully let go, so the car may not be held safely. Set it again, and if it keeps blinking, do not rely on it to hold the car on a slope.

What to do now

  1. Push the pedal or button down, or drop the lever all the way, and watch whether the light goes out.
  2. If the light stays on, check the brake fluid level in the see-through reservoir under the hood.
  3. Drive a short distance and see whether a rear wheel smells hot or the car feels like it is being held back.
  4. If the fluid is low or the pedal feels soft, do not drive it: have it looked at or towed.

Common causes

  • Parking brake not fully released
  • Sticking or misadjusted parking brake switch
  • Low brake fluid from worn pads or a leak
  • Seized or stretched parking brake cable
  • Faulty fluid level sensor in the reservoir cap
  • A brake system fault sharing the same red lamp

Checks you can do yourself

Safe, no tools in most cases

Do these with the car parked and the engine off and cool. If anything looks or smells hot, wait.

1
Release the brake fully and watch the light

With the car parked and your foot on the brake pedal, push the parking brake pedal or button all the way down, or drop the hand lever flat against the floor or console. Watch the red light while you do it. If it goes out, that was all it was. If it is a hand lever, lift it and drop it once more: the switch under the lever can stick partway.

2 minutes · None
2
Look at the brake fluid level

With the engine off and cool, open the hood and find the small see-through plastic tank near the back of the engine bay on the driver's side, usually marked with a circle and exclamation mark cap. Shine a light through the side and look for the MIN and MAX marks. Do not open the cap. If the fluid sits at or below MIN, that is why the light is on and it needs a shop.

5 minutes · A flashlight or phone light
3
Check whether a rear wheel is dragging

If the light stayed on, drive a few minutes at low speed around your street, then park. Stand beside each rear wheel and hold the back of your hand a few inches from the wheel without touching the brake parts. If one side throws off much more heat than the other, or you smell something hot, the parking brake is still partly clamped and the car should not be driven far.

10 minutes · None
4
Read what your own car calls the light

Open the owner's manual, or search the PDF version on your phone, for the warning light pages. Makes use this one red lamp for different things, and the manual tells you whether yours covers the parking brake only or the whole brake system. It also says whether a steady light and a blinking light mean different things on your car.

10 minutes · Owner's manual

Step-by-step repair walkthroughs for the fixes below are on the way.

What not to do

  • Don't drive with the lever or pedal partly engaged: it cooks the rear brakes and can cost you a brake job.
  • Don't keep driving to see if it clears when the light stays on with the brake released.
  • Don't just keep topping up the brake fluid to make the light go out: the fluid is going somewhere.
  • Don't park on a slope trusting the handbrake if the light blinks or the lever pulls up with no resistance.

What it usually turns out to be

Most likely first. Prices are typical US parts-and-labor totals for that repair, not a quote for your vehicle.

Parking brake left partly on, or a sticking switchPrice not verified

How you can tell The light goes out when you lift and firmly re-release the lever or pedal, or it flickers over bumps. A shop can watch the switch signal while moving the lever and see it stay closed when the brake is actually off.

The repair Adjust or replace the small switch at the base of the lever or pedal. It is a cheap part and a short job on most cars.

Low brake fluid from worn brake padsPrice not verified

How you can tell Fluid sits at or below the MIN line with no wet spots anywhere, and the pads look thin through the wheel. Often comes with a squeal or a grinding noise when you brake.

The repair Replace the worn pads, and the rotors if they are grooved or too thin, then set the fluid back to the full mark.

Brake fluid leak at a line, hose or caliperPrice not verified

How you can tell Fluid keeps dropping, the pedal feels soft or sinks slowly, and there is a damp or shiny spot on a wheel, behind a tire or under the master cylinder. This one is a safety problem, not a maintenance item.

The repair Replace the leaking hose, steel line, caliper or master cylinder, then bleed the brakes and refill the system.

Seized or stretched parking brake cablePrice not verified

How you can tell The lever pulls up much further than it used to, or it will not come back down, and the car still rolls when the brake is set. Common on cars that live in salt and snow.

The repair Replace the rusted or stretched cable and adjust the parking brake, including the rear shoes on cars that use them.

Faulty brake fluid level sensorPrice not verified

How you can tell The light is on but the fluid is right up at the full mark and the pedal feels normal. It often comes and goes with the fluid sloshing on corners.

The repair Replace the level sensor, which is part of the reservoir cap or clipped into the side of the tank.

What a shop will do

A shop starts by releasing the brake and watching the light, then checks the fluid level and the switch at the lever or pedal with a meter. If the fluid is low they look at every pad, hose and caliper for a leak. They will also pull codes from the brake and body modules, because some cars light this lamp from the ABS side. Plan on about half an hour to an hour before they can tell you what it is.

How to reset this light

This is not a reminder you reset after a service. It is a live warning, so it goes out on its own the moment the parking brake is fully off and the brake system reads as normal. Clearing it with a scan tool or pulling a fuse does nothing: it comes straight back until the switch, the fluid level or the leak behind it is actually repaired.

A few cars keep the lamp on until the key is cycled off and on after the fault is fixed.

Common questions

What does the parking brake light mean?

Your parking brake is applied, or the car thinks it is. On most cars the same red lamp also warns about the brake system itself, so if it stays on with the brake fully released, treat it as a brake problem.

Can I drive with the parking brake light on?

Release the parking brake and the light should go out within a second or two. If it goes out, you are fine to drive. If it stays on with the brake released, or the pedal feels soft or sinks toward the floor, stop driving and have the brakes checked or the car towed.

Is it safe to drive with the parking brake light on?

If the light goes out as soon as you fully release the brake, yes. If it stays on with the brake released, treat it as a brake system warning and get it checked before you drive again, because the usual cause is low fluid. A soft or sinking pedal means stop and call for a tow.

Why is my parking brake light on when the brake is off?

Two common reasons. The little switch at the lever or pedal is stuck and still telling the car the brake is set, or the brake fluid has dropped below the minimum mark and the car is using the same red lamp to warn you. Checking the fluid level tells you which one you have.

I drove a few miles with the handbrake on. Did I damage anything?

A short, slow drive usually just glazes the rear brake pads and makes a burning smell for a while. Longer or faster driving can overheat the rear brakes and warp the rotors, and on cars with rear drums it can ruin the shoes. If the car pulls, smells hot or one rear wheel is much hotter than the other, have the rear brakes looked at.

Will my car pass inspection with this light on?

In states that inspect brakes or check the dashboard, a red brake warning light on is normally a fail. If the light is on only because the handbrake was set, releasing it fixes the problem. If it stays on, expect to repair the cause before the car passes.

Does the parking brake light reset itself?

Yes, when the real cause is gone. It is a live warning, not a service reminder, so it switches off by itself once the brake is fully released and the fluid level and brake circuits read normal. There is no button or sequence to reset it.

Sources: Kia owner's manual · YourMechanic

Not your light? These get mixed up with it

Symbols vary a little between makes. Your owner's manual shows the exact lights for your vehicle. This is a general guide, not a diagnosis.