How to reset the oil change and tire pressure lights on a Honda
These two lights are reminders, not faults. Do the work first, then reset. Everything else on your dash is a warning, and clearing it does not fix anything.
Oil change or maintenance reminder
- Change the engine oil first, then do this reset so the Maintenance Minder starts counting on the new oil.
- Park the car, leave the engine off, and turn the power mode to ON by pressing the start button without pressing the brake.
- Press the Home button on the left side of the steering wheel.
- Roll the left selector wheel until the wrench icon appears, then press the wheel to open the Maintenance Minder screen.
- Press the left selector wheel again to enter reset mode; on some models you hold it in for about ten seconds to get there.
- Roll the wheel to the item you serviced, or choose All Due Items, then press the wheel to reset it.
- Check that the wrench icon and the oil life reading have cleared before you drive away.
Some 2019 and newer Pilot, Passport, Ridgeline and Odyssey models use the ENTER button on the steering wheel instead of a wheel: hold ENTER about ten seconds on the Oil Life screen.
- Reset this only after the oil has actually been changed, or the car will ask for its next service far too late.
- Park the car and turn the ignition to ON, position II, without starting the engine.
- Press SELECT/RESET over and over until the engine oil life reading shows on the information display.
- Press and hold SELECT/RESET for more than ten seconds, until the display switches into reset mode.
- Use the on-screen prompt to choose RESET, then press SELECT/RESET once more to confirm.
- Confirm the oil life reading has gone back to full and the wrench icon is gone.
The confirm step varies by model year: some cars reset as soon as the long hold finishes, others ask you to pick RESET first. Choosing CANCEL backs out without resetting.
Sources: Honda · Capital One Auto Navigator
Tire pressure (TPMS) light
- Set all four tires to the cold pressure on the driver's door jamb sticker before you touch any menu.
- Park on level ground, put the transmission in Park, and turn the power mode to ON.
- Open Settings from the home screen on the touchscreen, or scroll to Driver Information with the steering wheel buttons if the car has no touchscreen.
- Select Vehicle Settings, then select TPMS Calibration.
- Choose Calibrate and wait for the car to confirm it has started; run the menu again if it says calibration failed to start.
- Drive normally for about thirty minutes, mostly between 30 and 60 mph, to let calibration finish and the light go out.
This system compares how fast each wheel turns rather than reading sensors, so it has to be recalibrated after any pressure change, tire rotation or new tires.
- Set all four tires, and the full-size spare if it carries a sensor, to the door jamb sticker pressure first.
- Turn the ignition to ON and give the car a minute to read the sensors.
- Drive several miles at road speed so every sensor reports in; the low pressure light should go out by itself.
- If the light stays on, or flashes for about a minute at every startup, have a shop read the system with a TPMS tool, since these cars have no driver reset.
There is no menu reset to look for on this generation. A light that keeps returning at one corner usually means a sensor with a dead battery rather than low pressure.
Sources: Capital One Auto Navigator · Rick's Free Auto Repair Advice
Worth knowing on a Honda
Honda's Maintenance Minder shows a letter and number code, such as A1 or B12, for the work that is due; reset only the item you actually did so the rest stays on the books. Most Hondas built after about 2015 use indirect TPMS, so the tire light needs a calibration rather than a sensor relearn.