Tire pressure warning light (TPMS)
Also called: TPMS light, Low tire light
What it means
One or more tires is low on air. If the light flashes for about a minute and then stays on, a tire pressure sensor has a problem.
An amber light low in the instrument cluster shaped like a cross section of a tire, a flat bottomed horseshoe with an exclamation mark inside it. People often mistake it for a jar, a horseshoe or a cup. Some makes add the letters TPMS, or show a message such as CHECK TIRE PRESSURE or LOW TIRE PRESSURE, and many newer cars will also show the pressure at each wheel on a screen in the cluster or the center display.
Can I keep driving?
Usually yes, gently, to the nearest air pump. But if a tire looks flat, bulges at the bottom, or the car pulls or feels loose in corners, stop and fit the spare or call for a tow. If the light blinked for a minute before going solid, your pressures may be fine and it is the system that is broken, so check all four by hand.
If it's flashing or blinking: A flashing light means something different from a steady one. If it blinks for about a minute every time you start the car and then stays on solid, the system itself is at fault, usually a dead sensor in a wheel or sensors that were never matched to the car. Your tires may be perfectly fine, but the car can no longer warn you if one goes low, so you have to check them by hand.
What to do now
- Check all four tires with a gauge when they're cold.
- Fill to the pressure on the driver's door sticker, not the tire sidewall.
- If one keeps losing air, have it checked for a nail or leak.
Common causes
- Low tire pressure (cold weather drops pressure)
- Slow leak from a nail or bad valve
- Dead TPMS sensor battery
- Sensor not relearned after a tire rotation
Checks you can do yourself
Safe, no tools in most casesDo these with the car parked and the engine off and cool. If anything looks or smells hot, wait.
Do this before you drive, or after the car has sat at least three hours, because rolling heats the air and hides a low tire. Unscrew the cap on the valve stem, push the gauge straight on until the hissing stops, and read the number. Compare it with the figure on the sticker in the driver's door opening, not the much higher number moulded into the tire sidewall. Add air a little at a time and recheck.
15 minutes · Tire gauge, air pumpMix a squirt of dish soap into a cup of water and brush or pour it over the tread, around the wheel rim and over the valve stem of the tire that keeps going down. Watch for a patch of small bubbles that keeps growing, which marks the hole. Mark the spot with chalk or tape so the tire shop can find it straight away. A nail head often looks like a harmless dark speck until you get close.
10 minutes · Dish soap, waterOn many trucks, SUVs and vans the full size spare has its own sensor, so a soft spare can light the dash while all four tires on the ground are fine. Check your owner's manual to see whether yours is monitored, then check its pressure the same way. A spare that has sat for years is almost always low, and that is also worth knowing before you need it.
10 minutes · Tire gaugeMost cars switch the light off by themselves after ten to twenty minutes of normal driving above about twenty miles an hour. If yours has a reset button, the manual will show it under the steering wheel or in the glove box menu: with the ignition on and the engine off, hold it until the light blinks three times, then start the car and drive. If the light blinks for a minute at every start instead, no amount of driving will clear it.
20 minutes · Owner's manualStep-by-step repair walkthroughs for the fixes below are on the way.
What not to do
- Don't inflate to the big number on the tire sidewall, that is the maximum the tire can hold, not what your car wants.
- Don't keep driving on a tire that looks flat or squashed at the bottom, even for a mile, as the sidewall breaks up from the inside.
- Don't just reset the light and carry on without putting a gauge on all four tires.
- Don't ignore a light that keeps coming back every few weeks, that is a slow leak and slow leaks turn into blowouts.
What it usually turns out to be
Most likely first. Prices are typical US parts-and-labor totals for that repair, not a quote for your vehicle.
How you can tell All four tires read a few pounds low, and the light appeared on the first cold morning of the season or after a long spell of not driving. Tires lose a little air through the rubber every month on their own, and pressure falls by roughly one pound for every ten degrees the temperature drops. Nothing else is wrong.
The repair Add air to the pressure on the driver's door sticker and the light goes out on its own after a short drive.
How you can tell One tire only, and it keeps going down over days or hours while the other three hold steady. Soapy water bubbles at one spot in the tread. Very common after driving past building work or a parking lot being resurfaced.
The repair A tire shop takes the tire off the wheel and fits a patch plug from the inside, which is a permanent repair in the middle of the tread. Damage in the sidewall or shoulder cannot be repaired safely and needs a new tire.
How you can tell One tire goes soft with no nail anywhere in the tread, and the bubbles form right at the metal or rubber stem you put air into. Rubber stems go hard and crack with age, and the metal ones used with sensors corrode where road salt sits. Often shows up on cars around seven years old.
The repair The tire is taken off the wheel and a new stem or sensor service kit is fitted, which is usually done at the same time as a rotation.
How you can tell This is the flashing then solid light. The sensors are sealed units with a battery inside that lasts around seven to ten years, so they start dying one after another on an older car, often within a year of each other. The pressures are correct when you check them by hand.
The repair A tire shop breaks the tire bead, swaps in a new sensor and matches it to the car. Many people have all of them done at once on an older vehicle to avoid paying the tire labor four separate times.
How you can tell The light came on straight after new tires, a rotation, a seasonal wheel swap or a repair, and the pressures are all fine. Some cars learn the new positions by themselves after a few miles, others need a tool, and winter wheel sets with their own sensors need the swap registered each time.
The repair The shop runs a relearn with a scan tool so the car knows which sensor is at which corner. If the tires were just fitted somewhere, go back there first, as they will often do it at no charge.
How you can tell The least common cause by a long way. New sensors were fitted and the light still blinks, or the car reads no signal at all from any wheel. Can follow water getting into a control unit or a damaged antenna wire.
The repair The receiver or module is tested, then replaced and programmed to the car.
What a shop will do
At a tire shop the first move is a gauge on all four tires and the spare, then a look for a nail and a water tank dunk to find a leak you cannot see. That part is often quick and sometimes free. If the light blinks before it goes solid, they use a TPMS tool instead, which wakes each sensor in turn and shows its pressure, temperature and battery state, so a dead sensor and an unregistered one are told apart in a few minutes. A relearn is usually labor only with no parts.
How to reset this light
This light is designed to be reset once the work is done. Set every tire, and the spare if yours is monitored, to the pressure on the driver's door sticker while they are cold, then drive for ten to twenty minutes above about twenty miles an hour and the system relearns and switches the light off. If your car has a TPMS reset button, turn the ignition on without starting the engine, hold the button until the light flashes three times, release it, then start the engine and drive.
The procedure varies a lot by make, model and year, and some vehicles will only relearn with a shop scan tool. Your owner's manual has the one for your car.
Step by step
Pick your make for the button sequenceExact steps for every single year and model are still being added. If your make isn't here yet, your owner's manual has the sequence.
Walk through it step by step
Common questions
What does the tire pressure warning light (tpms) mean?
One or more tires is low on air. If the light flashes for about a minute and then stays on, a tire pressure sensor has a problem.
Can I drive with the tire pressure warning light (tpms) on?
Usually yes, gently, to the nearest air pump. But if a tire looks flat, bulges at the bottom, or the car pulls or feels loose in corners, stop and fit the spare or call for a tow. If the light blinked for a minute before going solid, your pressures may be fine and it is the system that is broken, so check all four by hand.
How long can I drive with the tire pressure light on?
If the tires only feel a little soft and look normal, driving gently to the nearest air pump is fine. If one tire looks low, bulges at the bottom or the car pulls or feels vague in corners, stop and put the spare on or call for a tow. A tire run badly low gets hot and can come apart at speed.
Does the tire pressure light reset itself?
Yes, in most cases. Once the pressures are correct the car sees the good readings and turns the light off after a short drive, usually within twenty minutes. If it does not clear after that, either a tire is still low or a sensor is at fault.
Why did it come on when it got cold?
Air shrinks as it cools, so pressure drops by about one pound for every ten degree fall in temperature. A tire that was fine in the fall can trip the warning on the first freezing morning. Top them up to the door sticker figure and they will be slightly high on a hot day, which is normal and expected.
Will it pass inspection?
In most states a tire pressure light on its own does not fail an inspection, though inspectors will almost always measure your tread depth and check the tires anyway. A few states that run a full safety check will note it. Worn out or damaged tires are a far more common reason to fail than the light itself.
Can I just have the sensors turned off?
Some scan tools can switch the system off on some vehicles, but it is a bad trade. You lose your only early warning of a slow leak, which matters most on a car with no spare. Fitting a working sensor usually costs less than one ruined tire.
Sources: J.D. Power · RepairPal