How to reset the oil change and tire pressure lights on a Jeep
These two lights are reminders, not faults. Do the work first, then reset. Everything else on your dash is a warning, and clearing it does not fix anything.
Oil change or maintenance reminder
- Change the engine oil and filter first. This reset only clears the reminder, it does nothing for the engine.
- With your foot off the brake, press the ENGINE START/STOP button once, or turn the key one click, so the ignition is in ON/RUN but the engine is not running.
- Press the down arrow on the steering wheel to scroll the cluster menu to Vehicle Info.
- Press the right arrow to open Vehicle Info, then scroll up or down to the Oil Life screen.
- Press and hold the OK button, which is the right arrow on some model years, until the oil life reads back at full.
- Press the up arrow to back out of the menu, then turn the ignition off.
- Start the engine and make sure the oil change message is gone.
Some model years answer with a Reset then Yes prompt you confirm with the arrow buttons before the oil life goes back to full.
- Do this only after the oil and filter have actually been changed.
- Without pressing the brake pedal, put the ignition in ON/RUN without starting the engine.
- Press the accelerator pedal all the way to the floor slowly, three times, within ten seconds.
- Put the ignition back in the OFF position.
- Start the engine and check that the oil change message is gone. If it still shows, the sequence did not take, so repeat it.
This pedal sequence is the factory fallback across Jeep, Dodge and Ram, so it is worth trying when the menu method is missing.
Sources: ManualsLib · Mopar vehicle information · Capital One Auto Navigator
Tire pressure (TPMS) light
- First set all four tires to the cold pressure printed on the sticker in the driver's door opening, using a gauge you trust.
- Set the spare too if your Jeep carries a matching full-size spare, because those have a sensor in them.
- Check the pressures cold. A tire that has just been driven on reads high, and setting it then leaves you underinflated.
- Start the Jeep and drive it normally, keeping above about fifteen miles an hour for up to twenty minutes.
- The tire pressure light goes out by itself once the system has read all the corrected pressures. Nothing in the menus has to be touched.
If the light returns within a day or two, you have a slow leak or a dying sensor, not a reset problem.
- Set every tire to the door-sticker pressure first, the spare included if it is monitored.
- Leave the Jeep parked for at least twenty minutes, then drive it for twenty minutes at a steady speed above fifteen miles an hour so the module can pick up the new sensor IDs.
- If the light or the SERVICE TPM SYSTEM message is still showing after that drive, the sensor IDs have to be written into the module with a TPMS tool at a shop. There is no in-car button sequence for it.
A light that flashes for about a minute and a quarter and then stays solid is reporting a system fault, not low air.
Sources: ManualOwl · Modern Tire Dealer · Mitchell 1
Worth knowing on a Jeep
Jeep oil life is calculated from how the vehicle is actually driven, not from a mileage counter you can dial in, so the reminder can come up earlier than you expect in short-trip or towing use. Neither reset needs a scan tool. Exact menu wording and which button confirms the reset shift from one model year to the next, so follow what your own cluster shows.