Home › Warning lights › Reset a light › Hyundai
Reset a reminder light

How to reset the oil change and tire pressure lights on a Hyundai

These two lights are reminders, not faults. Do the work first, then reset. Everything else on your dash is a warning, and clearing it does not fix anything.

Oil change or maintenance reminder

1Most models 2019 and newer with a touchscreen and an oil life display
  1. Change the engine oil and filter first, then do this reset only after the fresh oil is in the car.
  2. With the vehicle switched on and parked, tap Setup on the center touchscreen.
  3. Choose Vehicle, then Convenience, then Oil Change Reminder.
  4. Select Reset.
  5. When the screen asks whether the engine oil has been changed, select Yes to reset the oil life.
  6. Switch the car off and back on and confirm the oil life reads full again.

Hyundai's Oil Life Management System estimates remaining oil life from how you drive, so the reading stays wrong until you reset it after every oil change.

2Older models with a Service Interval or Service in countdown in the gauge cluster
  1. Finish the oil change first; the countdown is only cleared once the service is actually done.
  2. With the car parked and the ignition on, press the Mode or arrow buttons on the steering wheel to reach User Settings in the cluster.
  3. Scroll to the Service Interval item, which may sit under a Convenience or Cluster submenu.
  4. Choose Reset and confirm with the OK button on the steering wheel.
  5. Check that the display now shows the full mileage until the next service.

Menu wording and the exact submenu vary by model year, and some cars have the feature turned off from the factory. If you cannot find it, any Hyundai dealer can reset it.

Sources: Hyundai owner's manual

Tire pressure (TPMS) light

1Most US models that show a pressure number for each tire and have no TPMS reset button
  1. Set all four tires, and the spare if it has a sensor, to the pressure on the driver's door jamb sticker, checking them cold.
  2. Switch the ignition on and let the cluster finish its startup checks.
  3. Drive the car at a steady road speed for about ten minutes so each sensor reports its new pressure.
  4. Watch the tire pressure page in the cluster; once all four numbers look right, the low pressure light goes out on its own.
  5. If the light stays on or blinks for about a minute at every start, have the sensors and tires checked for a leak or a dead sensor battery.

These systems learn pressures by themselves, so there is no button sequence to press. A light that blinks at startup points to a system fault, not just low pressure.

2Models whose cluster has a Tire Pressure menu with a Set option
  1. Inflate all four tires to the door jamb sticker pressure while they are cold, meaning parked about three hours or driven less than a mile.
  2. Leave the car parked and switch the ignition on.
  3. Press the menu button on the steering wheel and use the up and down switches to bring up Tire Pressure.
  4. Press and hold the OK button on the steering wheel, then choose Set.
  5. Confirm the cluster shows a tire pressures stored message and the low tire pressure light blinks for a few seconds.
  6. If neither happens, repeat the steps from the steering wheel menu.

Reset only with correct pressures in all four tires; storing low pressures can leave the warning silent when a tire really is flat.

Sources: Hyundai owner's manual

Worth knowing on a Hyundai

Hyundai treats these as two separate reminders: the oil life reminder lives in the touchscreen Setup menus, while tire pressure is handled in the gauge cluster. Resetting either one before the work is done only hides a real problem.

If the light comes straight back

Hyundai models on the site

Button sequences vary by model year and trim. Your owner's manual is the final word for your exact vehicle. If a reminder will not clear after the service, something else is setting it.