How to reset the oil change and tire pressure lights on a Nissan
These two lights are reminders, not faults. Do the work first, then reset. Everything else on your dash is a warning, and clearing it does not fix anything.
Oil change or maintenance reminder
- Have the oil and filter actually changed first. This reminder is only a distance counter, so clearing it before the service just hides your schedule.
- Park the vehicle, set the parking brake, and turn the ignition to ON without starting the engine. The menu is locked out while the vehicle is moving.
- Press the display buttons on the left side of the steering wheel until Settings appears in the gauge-cluster display.
- Scroll to Maintenance and press OK or the scroll dial to open it.
- Highlight the engine oil item, which may read Service, Engine Oil, or Oil Life depending on the model, and press OK.
- Follow the reset prompt shown at the bottom of that screen and press OK or Yes to put the countdown back to a full interval.
If your Nissan also counts the oil filter as its own item, reset that one the same way. Menu wording changes from one model year to the next, so follow the prompt on the screen rather than a fixed number of presses.
- Change the oil and filter first, then reset. On these Nissans the interval distance is one you set yourself, so the reminder means nothing until the work is done.
- Stop the vehicle, set the parking brake, and turn the ignition to ON. The display will refuse changes while you are driving.
- Rotate the INFO dial, or press the display button on the instrument panel, until the maintenance screen appears.
- Press the dial to open the menu, which lists engine oil, oil filter, tires, and other.
- Highlight the engine oil item and choose the reset option on that screen to clear the distance counted since the last change.
- Repeat for the oil filter item if your Nissan lists it, then press BACK to leave. The setting saves on its own.
Exact labels and the dial location differ by model. Set the interval to match the distance in your Nissan service and maintenance guide before you reset it.
Sources: Nissan · ManualOwl
Tire pressure (TPMS) light
- Set all four tires to the cold pressure on the driver's door-jamb label first. This light reports real low pressure, so there is nothing to clear until the air is right.
- Park on level ground, set the parking brake, shift to P, and turn the ignition to ON without starting the engine.
- Start adding air to one tire. A few seconds in, the hazard lights begin flashing to show the car is watching that tire.
- Stop when the horn gives one short beep and the hazards stop flashing. That tire has reached the placard pressure.
- If the horn beeps and the hazards flash three times, you went past it. Press the valve stem core briefly to bleed air back down.
- Repeat on the remaining tires, and check the spare with a hand gauge if your model monitors it.
- Drive above 16 miles per hour for several minutes. The warning light goes out by itself once the system has re-read every tire.
There is no reset button for this light on a Nissan. Correct pressures plus a short drive is the reset.
- Set every tire to the door-jamb cold pressure with a gauge before you open the menu.
- Park on level ground, set the parking brake, shift to P, and turn the ignition to ON.
- Use the steering wheel display buttons to bring up Settings in the gauge-cluster display.
- Scroll to the tire pressure item, open it, and choose Calibrate.
- Select Yes to confirm, then drive above 16 miles per hour for several minutes to let the system finish.
Not every Nissan has this item. If Settings has no tire pressure entry, your car uses the inflate-and-drive method instead, and that is normal.
- Set all four tires to the door-jamb pressure and drive a few miles to rule out a simple low tire.
- A light that flashes for roughly a minute and then stays lit is reporting a system fault, not low pressure, so no button sequence will clear it.
- Registering sensor IDs after a wheel, tire, or sensor change needs a shop tool that puts the body control module into learn mode through the OBD port under the dash.
- Have a Nissan dealer or a tire shop with TPMS equipment register the sensors and confirm the light goes out.
Mounting the spare also stops the system until it is reset, so expect the light until the regular wheel goes back on.
Sources: NiSentra · Nissan · Brake & Front End
Worth knowing on a Nissan
Nissan's maintenance menu counts down a distance you set yourself, so resetting it is only meaningful after the oil is really changed. The low tire pressure light is a true pressure warning on every Nissan sold here, not a service reminder, and it clears after correct inflation and a short drive rather than from a button.