How to reset the oil change and tire pressure lights on a Infiniti
These two lights are reminders, not faults. Do the work first, then reset. Everything else on your dash is a warning, and clearing it does not fix anything.
Oil change or maintenance reminder
- Change the oil and filter first. The reminder is a distance counter you set, so resetting it before the service only hides when the car is actually due.
- Park the vehicle, set the parking brake, and turn the ignition to ON without starting the engine. The settings will not open while you are driving.
- Press the display or ENTER buttons on the left side of the steering wheel until Settings appears in the gauge-cluster display.
- Scroll to Maintenance and press ENTER, then highlight the engine oil item.
- Choose the reset option shown on that screen and confirm it to put the countdown back to the full interval.
- Reset the oil filter item the same way if your Infiniti lists it separately, then press BACK to leave the menu.
Labels differ across Q50, Q60, QX50, QX60, and QX80 model years, and I could not confirm one fixed sequence for every one of them. Follow the prompt the screen shows rather than counting presses.
- Have the oil and filter changed first. This screen only tracks the distance you entered for the interval, so it means nothing until the work is done.
- Stop the vehicle and set the parking brake, then turn the ignition to ON. The display will not accept changes while the car is moving.
- Rotate the INFO dial until the maintenance screen appears, then press the dial to enter the menu.
- Highlight the engine oil item from the list of engine oil, oil filter, tires, and other.
- Select the reset key on that screen, usually shown as a reset distance choice, to clear the distance counted since the last change.
- Press BACK to return to the previous screen. The setting saves by itself.
These cars let you pick your own interval distance, so check it against the Infiniti service and maintenance guide before you reset. Exact key names vary by model year.
Sources: ManualOwl
Tire pressure (TPMS) light
- Set all four tires to the cold pressure on the driver's door-jamb label first. This light reports genuine low pressure, so there is nothing to clear until the air is correct.
- Park on level ground, set the parking brake, shift to P, and turn the ignition to ON without starting the engine.
- Begin adding air to one tire. After a few seconds the hazard lights start flashing to confirm the car is reading that tire.
- Stop adding air when the horn gives one short beep and the hazards stop. That tire is at the placard pressure.
- If the horn beeps and the hazards flash several times, you overfilled it. Press the valve stem core briefly to let air back out.
- Repeat on the other tires, then check the spare with a hand gauge.
- Drive above 16 miles per hour for several minutes. The system only works above that speed, and the light goes out once it has re-read the tires.
Infiniti calls this the tire pressure monitoring system with tire inflation indicator. There is no owner reset button for the light itself.
- Check all four tires with a gauge and set them to the cold pressure on the driver's door-jamb label.
- Reinstall the valve stem caps and check the spare as well.
- Inflating alone will not turn the light off, so drive the car above 16 miles per hour for a few minutes.
- The light goes out on its own once the monitoring system has re-read each tire. There is no menu item or button to clear it.
If the light comes back within a day or two, one tire is leaking. Have the tire and the valve checked rather than resetting anything.
- Set all four tires to the door-jamb pressure and drive a few miles to rule out a simple low tire.
- A light that blinks for roughly a minute and then stays lit is reporting a fault in the system, not low pressure, and no button sequence will clear it.
- Mounting the spare or fitting a new wheel stops the system until the sensor IDs are registered again, which needs a shop tool through the OBD port under the dash.
- Have an Infiniti retailer or a tire shop with TPMS equipment reset the system and confirm the light goes out.
Sources: ManualOwl · INFINITI owner information · Brake & Front End
Worth knowing on a Infiniti
Infiniti shares Nissan's hardware, so the maintenance menu is a distance counter you set yourself and the low tire pressure light is a real pressure warning rather than a service reminder. Infiniti manuals send owners to the retailer for a system reset after a wheel or sensor change instead of giving a button sequence.