How to reset the oil change and tire pressure lights on a Ram
These two lights are reminders, not faults. Do the work first, then reset. Everything else on your dash is a warning, and clearing it does not fix anything.
Oil change or maintenance reminder
- Change the engine oil and filter first, then do this reset so the oil life counter matches the fresh oil.
- Without pressing the brake, push the ENGINE START/STOP button once to put the ignition in ON/RUN, but do not start the engine. With a key, turn it to ON instead.
- Press the down arrow on the steering wheel to scroll the cluster menu to Vehicle Info.
- Press the right arrow to open Vehicle Info, then use the up or down arrow until Oil Life is highlighted.
- Press and hold the right arrow until Reset appears on the Oil Life screen.
- Press the down arrow to highlight Yes, then press the right arrow to confirm. The oil life returns to full.
- Press the up arrow to back out, then start the truck and check that the oil change message is gone.
On trucks with an OK button in the middle of the arrow pad, hold OK on the Oil Life screen instead of holding the right arrow.
- Change the oil and filter before you reset anything, so the service reminder is counting from the new oil.
- Turn the ignition key to ON or RUN without starting the engine and without pressing the brake pedal.
- Press the accelerator pedal all the way to the floor slowly, let it up, and do that three times inside ten seconds.
- Turn the ignition back OFF, then start the truck and confirm the oil change message no longer shows.
This is the Stellantis pedal method. Exact steps vary by model year, so if the message stays, try the Vehicle Info menu reset above.
Sources: Mopar vehicle information · ManualsLib
Tire pressure (TPMS) light
- Set the pressures first. With the tires cold, inflate all four to the cold pressure printed on the sticker in the driver's door opening, not to the number molded in the tire sidewall.
- If your truck has a full-size spare that is monitored, set it to the same door-sticker pressure.
- Look at the cluster tire graphic. The low tire is called out in a different color with an Inflate To message that names the target pressure.
- If you are filling warm tires, you may need to add up to 4 psi over the door-sticker number for the system to see the tire as full.
- Drive the truck normally. It can take up to 20 minutes of driving above 15 mph before the sensors report in and the light goes out on its own.
- Recheck the pressures cold the next morning and bleed off any extra air you added to warm tires.
Ram has no in-cab TPMS reset. Correct the pressures and the system clears itself.
- Confirm all four tires, and the monitored spare, really are at the door-sticker pressure with your own gauge.
- If the light blinks at every start, that is the system telling you it has a fault, not that a tire is low.
- Expect a dead sensor battery, a damaged sensor, or a sensor that was not programmed after new wheels or tires.
- Have a shop read the sensor IDs with a TPMS tool and relearn or replace the bad sensor. This part cannot be done from the driver's seat.
Sources: Mopar vehicle information
Worth knowing on a Ram
Ram oil change reminders are mileage and driving based, not an oil quality sensor, so the reset only tells the truck you did the work. Diesel trucks also track an exhaust filter service that is separate and is not reset this way.