Home › Warning lights › Reset a light › Cadillac
Reset a reminder light

How to reset the oil change and tire pressure lights on a Cadillac

These two lights are reminders, not faults. Do the work first, then reset. Everything else on your dash is a warning, and clearing it does not fix anything.

Oil change or maintenance reminder

1Most Cadillacs from the mid-2000s on with a Driver Information Center in the cluster
  1. Change the oil and filter first; the reminder should only be reset after the fresh oil is in.
  2. Turn the ignition to ON or RUN with the engine off.
  3. Use the DIC buttons on the right side of the steering wheel to bring up Oil Life or Remaining Oil Life in the cluster.
  4. With that reading on screen, press and hold the SEL or check-mark button at the center of the DIC control for a few seconds.
  5. Release it when the oil life reading returns to full and the Change Engine Oil Soon message clears.
  6. Restart the engine and make sure the message does not reappear.

On CUE and newer screens the oil life page may sit under the cluster Info or Vehicle menu rather than a dedicated button.

2Older Cadillacs, or any model where the menu reset will not hold
  1. Only do this once the oil change is actually finished.
  2. Turn the ignition on with the engine off; do not crank the engine.
  3. Press the accelerator pedal fully to the floor and release it three times within five seconds.
  4. Turn the ignition off, then start the engine and watch the display.
  5. If the Change Engine Oil Soon message comes back, the reset failed and the pedal sequence needs to be repeated faster.

This GM pedal method is documented in Cadillac owner manuals as the alternative to the DIC reset.

Sources: ManualOwl · ManualsDir

Tire pressure (TPMS) light

1Newer Cadillacs, roughly 2020 and later, with automatic sensor learning
  1. Set all four tires, and the spare if it carries a sensor, to the pressure on the Tire and Loading Information label in the driver's door opening.
  2. Leave the car parked and shut off for about twenty minutes after the tires were rotated, replaced or inflated.
  3. Drive normally for up to ten minutes, keeping the speed above about twelve miles per hour.
  4. Check the tire pressure page in the cluster; each corner should show a pressure instead of a dash and the warning light should go out.
  5. If a corner still shows a dash or a warning message appears, the sensors or the relearn need shop equipment.

There is no button sequence on these models; the relearn happens while driving.

2Cadillacs from about 2013 through 2019 with the five-way DIC control on the steering wheel
  1. Set all four tires, and the monitored spare if fitted, to the pressure on the label in the driver's door opening.
  2. Set the parking brake and put the power mode in ON or RUN with the engine off.
  3. In the cluster Settings menu, make sure the tire pressure display is turned on.
  4. Scroll with the five-way DIC control on the right of the steering wheel to the Tire Pressure screen, then press and hold the SEL button in its center until the horn sounds twice and TIRE LEARNING ACTIVE appears.
  5. Hold a TPMS relearn tool against the driver front tire sidewall by the valve stem and press its button; one horn chirp means that sensor matched.
  6. Repeat at the passenger front, passenger rear, then driver rear; two horn sounds signal the end of the process.
  7. Finish the first tire within two minutes and all four within five minutes, or the process cancels and must be started over.

A relearn tool from a dealer or tire shop is required; the DIC alone cannot reassign sensor positions.

3Cadillacs from about 2007 through 2012 with keyless entry
  1. Set all four tires, and the spare if it is monitored, to the pressure on the driver's door label.
  2. Set the parking brake and turn the ignition to ON or RUN with the engine off.
  3. Hold the LOCK and UNLOCK buttons on the key fob at the same time for about five seconds, until the horn sounds twice.
  4. At the left front tire, hold a TPMS activation tool against the sidewall near the rim at the valve stem and press its button, then wait for the horn chirp.
  5. Work around the car in the order left front, right front, right rear, left rear, waiting for a chirp at each.
  6. Turn the ignition off after the last chirp; if any sensor takes more than two minutes, learn mode cancels and the whole sequence repeats.

If a sensor will not read, roll the car forward a foot or two; brake parts can block the signal at the front wheels.

Sources: ManualOwl · ManualsLib · Brake & Front End

Worth knowing on a Cadillac

Cadillac shares GM's oil life and TPMS systems, so Escalade, CTS, ATS, XT4, XT5, CT4 and CT5 follow the same patterns by era. A failed or interrupted TPMS relearn clears the stored sensor positions and shows dashes, so the full procedure has to be redone.

If the light comes straight back

Cadillac models on the site

Button sequences vary by model year and trim. Your owner's manual is the final word for your exact vehicle. If a reminder will not clear after the service, something else is setting it.