How to reset the oil change and tire pressure lights on a Toyota
These two lights are reminders, not faults. Do the work first, then reset. Everything else on your dash is a warning, and clearing it does not fix anything.
Oil change or maintenance reminder
- Do this only after the engine oil and filter have actually been changed; the reminder is just a distance counter and clearing it early only hides the next due date.
- Turn the ignition to ON without starting the engine. With push-button start, keep your foot off the brake and tap the power button twice.
- Use the arrow buttons on the steering wheel to scroll the display between the gauges to the gear-shaped Settings icon.
- Press OK to open it, then move to Vehicle Settings and hold OK until the sub-menu opens.
- Choose Scheduled Maintenance, or Oil Maintenance if your display lists that separately.
- At the Reset Data? prompt choose Yes and press OK.
- Turn the ignition off and back on and confirm the MAINT REQD or Maintenance Required message is gone.
Menu wording shifts a little by model and year; look for Vehicle Settings first, then whichever item is named for maintenance.
- Finish the oil and filter change first, then reset the light so the next interval counts from the right mileage.
- Turn the ignition to ON and press the ODO/TRIP button until the display shows Trip A.
- Turn the ignition back off.
- Hold the ODO/TRIP button down and, while still holding it, turn the ignition to ON without starting the engine.
- Keep holding until the trip display runs down to zeros and the MAINT REQD light flashes and then goes out.
- Release the button and switch the ignition off.
This trip-meter method only works on clusters with a real trip meter button; the exact button name and location vary by model year.
Sources: Tustin Toyota
Tire pressure (TPMS) light
- First set all four tires, and the spare if it carries a sensor, to the cold pressure printed on the driver's door jamb sticker.
- Park somewhere safe and switch the vehicle off; the system will not initialize while the car is moving.
- Turn the ignition to ON without starting the engine.
- Press and hold the tire pressure warning reset switch until the tire pressure warning light blinks slowly three times, then release it.
- Drive at about 25 mph or more for roughly ten minutes so the system learns the corrected pressures.
The switch sits below the steering wheel on most cars, and low in the dash or near the glove box on some trucks and vans.
- Correct all four tire pressures, plus a monitored spare, to the door-sticker cold figure before you touch anything inside the car.
- Turn the ignition to ON without starting the engine.
- Use the steering wheel arrows to open the gear-shaped Settings menu on the display between the gauges.
- Select Vehicle Settings, then the TPMS or tire pressure item.
- Press and hold OK until the tire pressure warning light blinks three times.
- Drive at about 25 mph or more for about ten minutes for the light to clear.
Many newer Toyotas relearn on their own after a short drive once the pressures are right, with no menu step at all.
Sources: ManualsLib
Worth knowing on a Toyota
Toyota's MAINT REQD reminder counts miles, it does not measure oil condition, so it will come back on schedule whether or not the oil was changed. A tire pressure light that blinks for about a minute and then stays solid is a system or sensor fault, not low air, and no reset sequence will clear it.