How to reset the oil change and tire pressure lights on a Volkswagen
These two lights are reminders, not faults. Do the work first, then reset. Everything else on your dash is a warning, and clearing it does not fix anything.
Oil change or maintenance reminder
- Only reset the reminder after the oil and filter have actually been changed, with the car parked.
- Turn the ignition to ON without starting the engine.
- Use the arrow and OK buttons on the steering wheel to open the Settings menu in the instrument cluster display.
- Scroll to Service and press OK.
- Select the oil change or service entry, choose Reset, and press OK.
- Press OK once more to confirm; the display should show a full interval again.
On models where the service menu lives on the touchscreen instead, the same reset sits under Car, then Settings, then Service. Menu wording varies by model year.
- Change the oil first; the reminder is only a counter and resetting it early hides a real service.
- Turn the key to ON without starting the engine.
- Open the Settings menu with the button on the end of the wiper stalk, or with the menu buttons on the steering wheel.
- Scroll to Service and press OK.
- Choose Reset and press OK, then press OK again to confirm.
Some cars of this era label the entry Service Interval or Oil Change rather than Service.
- With the oil already changed and the ignition off, press and hold the 0.0 or SET trip reset button on the instrument cluster.
- Keep holding it while you turn the ignition to ON without starting the engine.
- Release the button once the service message appears in the display.
- Press the clock or minute button once; the service display should clear.
Button names and positions differ between clusters. On a number of 2010 and newer Volkswagens the interval can only be reset with a scan tool, so if no in-car method works, that is why.
Sources: YourMechanic · Ross-Tech Wiki
Tire pressure (TPMS) light
- First set all four tires to the pressure printed on the sticker in the driver's door opening, with the tires cold.
- Turn the ignition to ON and leave the car parked.
- Open the Settings or Car menu in the instrument cluster display or on the touchscreen.
- Select Tires or Tire Pressure.
- Choose Store or Set to save the current pressures as the new reference, and confirm.
- Drive normally for at least twenty minutes so the system learns the new values.
Most Volkswagens sold here use an indirect system that watches wheel speed rather than reading sensors, so it has to be re-taught after any pressure change, rotation or tire swap.
- Set all four tires to the door sticker pressure first, while the tires are cold.
- Turn the ignition to ON without starting the engine.
- Press and hold the SET button until the display or the warning light confirms the new pressures are stored.
- Release the button and drive normally so the system can finish learning.
Volkswagen's own guidance is to store the corrected pressures either with the set button or through the menu display, whichever your car has.
- Set all four tires to the door sticker pressure first.
- Turn the ignition on and open the tire pressure page to see whether a separate pressure is listed for each tire.
- If individual pressures are listed, the car reads real sensors, and new sensors must be matched to the car electronically.
- Have a tire shop or dealer run the sensor relearn with a scan tool; there is no button sequence that will do this.
Simply correcting pressures on these cars still only needs the store or SET step. Only new sensors or a new set of wheels needs the shop.
Sources: Volkswagen · Vehicle Service Pros
Worth knowing on a Volkswagen
Because most Volkswagens use an indirect tire pressure system, the light comes back if you only add air without storing the new pressures. Resetting an oil reminder changes the counter and nothing else, so follow the maintenance schedule rather than the light.