Reset a reminder light

How to reset the oil change and tire pressure lights on a Buick

These two lights are reminders, not faults. Do the work first, then reset. Everything else on your dash is a warning, and clearing it does not fix anything.

Oil change or maintenance reminder

1Most Buicks from the mid-2000s on with a Driver Information Center in the gauge cluster
  1. Change the engine oil and filter first; only reset the reminder after the fresh oil is in the engine.
  2. Turn the ignition to ON or RUN with the engine off, or start the engine and leave it idling.
  3. Use the DIC buttons on the right side of the steering wheel to scroll the cluster display to Oil Life or Remaining Oil Life.
  4. With that screen showing, press and hold the SEL or check-mark button in the middle of the DIC control for a few seconds.
  5. Let go when the oil life reading jumps back to full and the Change Engine Oil Soon message clears.
  6. Turn the ignition off, then restart the engine and confirm the message does not come back.

The reset button is marked SEL, a check mark, or a V depending on the year and model.

2Older Buicks with no oil life item in the menu, or when the menu reset will not take
  1. Do this only after the oil and filter have actually been changed.
  2. Turn the ignition to ON or RUN with the engine off; do not start the engine.
  3. Fully press the accelerator pedal to the floor and release it three times within five seconds.
  4. Turn the ignition off, then start the engine and check the display.
  5. If the Change Engine Oil Soon message is still showing, the reset did not take, so repeat the whole sequence.

This is the GM backup method and the timing is strict; it fails if the three pedal presses take longer than five seconds.

Sources: Ask Manual · ManualsDir · ManualOwl

Tire pressure (TPMS) light

1Newer Buicks, roughly 2020 and later, that relearn tire positions on their own
  1. Set all four tires, and the spare if it has a sensor, to the pressure on the Tire and Loading Information label inside the driver's door opening.
  2. Leave the vehicle parked and switched off for about twenty minutes so the system can settle after the tires were moved or inflated.
  3. Drive normally for up to ten minutes at a steady speed above about twelve miles per hour on a quiet road.
  4. Check the tire pressure page in the cluster display; the pressures should fill in at the correct corners and the warning light should go out.
  5. If the light stays on or a corner still shows dashes, the sensors need a relearn with a TPMS tool at a shop.

Nothing is pressed on these models; relearn happens by driving. Confirm against your own owner's manual, since the cutover year varies by model.

2Buicks from about 2013 through 2019 with a five-way DIC control on the steering wheel
  1. Set all four tires, and the spare if it is monitored, to the pressure on the label inside the driver's door opening.
  2. Set the parking brake and turn the ignition to ON or RUN with the engine off.
  3. Use the DIC control on the right side of the steering wheel to scroll to the Tire Pressure screen.
  4. Press and hold the SEL button in the center of that control until the horn sounds twice and a tire learning message appears.
  5. Starting at the driver front tire, hold a TPMS relearn tool against the tire sidewall just below the valve stem and press its button; a single horn chirp means that sensor was learned.
  6. Repeat at the passenger front, then passenger rear, then driver rear; two horn sounds at the end mean the relearn finished.
  7. Turn the ignition off; the first tire must be learned within two minutes and all four within about five minutes or the process restarts.

A TPMS relearn tool is required for this method; there is no pedal or button shortcut that replaces it.

3Buicks from about 2007 through 2012 with keyless entry
  1. Set all four tires, and the spare if it is monitored, to the pressure on the label inside the driver's door opening.
  2. Set the parking brake and turn the ignition to ON or RUN with the engine off.
  3. Press and hold the LOCK and UNLOCK buttons on the key fob together for about five seconds, until the horn sounds twice.
  4. Starting at the left front tire, hold a TPMS activation tool against the sidewall near the rim at the valve stem and press its button; wait for the horn chirp.
  5. Move around the vehicle in the order left front, right front, right rear, left rear, waiting for a chirp at each one.
  6. Turn the ignition off when the last sensor is learned; each sensor must be picked up within two minutes or learn mode cancels.

On many models the turn signal lights up at the corner the system is waiting for.

Sources: Brake & Front End · Tire Review · Modern Tire Dealer

Worth knowing on a Buick

Buick uses the same oil life and TPMS systems as the rest of GM, so the sequences carry across Enclave, Encore, Envision, LaCrosse, Regal and Verano of the same era. GM TPMS relearns need a relearn tool on most years; letting air out of the tires is not a substitute.

If the light comes straight back

Buick models on the site

Button sequences vary by model year and trim. Your owner's manual is the final word for your exact vehicle. If a reminder will not clear after the service, something else is setting it.