Reset a reminder light

How to reset the oil change and tire pressure lights on a Kia

These two lights are reminders, not faults. Do the work first, then reset. Everything else on your dash is a warning, and clearing it does not fix anything.

Oil change or maintenance reminder

1Most models 2020 and newer with a touchscreen, including the EV6 and other EVs
  1. Change the oil and filter first, or have the scheduled service done, and only then clear the reminder.
  2. With the car parked and switched on, tap Setup on the center touchscreen.
  3. Choose Vehicle, then Cluster, then Service Interval.
  4. Select Reset to start the countdown over.
  5. Switch the car off and back on; the Service in message should no longer appear at startup.

Kia counts down by both distance and time, and it starts warning when the service is close, so the message can return on time alone even with miles left.

2Models where the reminder is set in the gauge cluster, such as the Carnival and Telluride
  1. Do the oil change first; the reminder means nothing until the service has actually been performed.
  2. Start the engine and leave it running so the battery stays charged while you change settings.
  3. Press the Mode button on the steering wheel until the cluster shows User Settings.
  4. Scroll to Convenience and open the Service Interval items.
  5. Choose Reset and confirm with the OK button on the steering wheel.
  6. Confirm the cluster now shows a full interval until the next service.

Kia's own manual says to consult a dealer to use the service interval menu, and the same menu also holds Enable Service Interval and Adjust Interval settings.

Sources: Kia owner's manual

Tire pressure (TPMS) light

1Most US models that show a pressure number for each tire and have no TPMS SET button
  1. Set all four tires, and the spare if it is monitored, to the pressure on the driver's door jamb label, checking them cold.
  2. Switch the ignition on and let the cluster finish its startup checks.
  3. Drive at a steady road speed for about ten minutes so every sensor reports in.
  4. Open the tire pressure page in the cluster and confirm all four readings match the label; the low pressure light then clears itself.
  5. If the light stays lit, or blinks for about a minute each time you start the car, have the sensors, valve stems and tires inspected.

Nothing needs to be pressed on these cars. A blinking light at startup is a system fault, such as a dead sensor battery, rather than simple low pressure.

2Models fitted with a TPMS SET button, usually low on the dash or near the driver's knee
  1. Park on level ground and inflate every tire to the door jamb label pressure while the tires are cold.
  2. Start the engine and leave the car standing still; the button does nothing while the car is moving.
  3. Press and hold the TPMS SET button for a little more than three seconds.
  4. Watch for the low tire pressure light to blink for about four seconds and go out, or for a tire pressures stored message in the cluster.
  5. Drive for roughly twenty minutes so the system settles on the new pressures.
  6. If the warning light comes back on, repeat the whole procedure from the pressure check.

Whatever pressures are in the tires at reset become the system's reference, so resetting on soft tires can leave you without a warning when one really goes down.

Sources: Kia owner's manual

Worth knowing on a Kia

Kia does not show an oil life reading on most US models; it uses a mileage and time Service Interval countdown that an owner or dealer resets. Tire pressure is always handled in the cluster, never in the touchscreen.

If the light comes straight back

Kia models on the site

Button sequences vary by model year and trim. Your owner's manual is the final word for your exact vehicle. If a reminder will not clear after the service, something else is setting it.