How to reset the oil change and tire pressure lights on a Mazda
These two lights are reminders, not faults. Do the work first, then reset. Everything else on your dash is a warning, and clearing it does not fix anything.
Oil change or maintenance reminder
- Change the oil and filter first, then do this reset only after the fresh oil is in, since the counter is based on distance and not on the oil itself.
- Turn the ignition to ON without driving off, so the center display comes up on its home screen.
- Select the Applications icon on the home screen, using the touchscreen or the commander knob by the shifter.
- Select Vehicle Status Monitor, then select Maintenance to open the maintenance list.
- Move to the Oil Change tab and select Reset, which puts the remaining distance back to its full value.
- Check that the oil change message or wrench light no longer shows when you restart the car.
On the 2.5 turbo gas and 2.2 diesel engines the manual also calls for an engine control unit reset at a Mazda dealer after every oil change.
- Complete the oil and filter change first, then turn the ignition to ON with the car parked.
- Bring up the home screen on the center display and open the Applications screen.
- Select Maintenance to display the maintenance list.
- Move to the Oil Change tab and select the Reset item to return the remaining distance to its starting value.
- Restart the car and confirm the oil change reminder is gone.
Mazda says to do this every time the oil is changed, whether or not the wrench light or message has appeared yet.
- Change the oil and filter first, then note the mileage on the service sticker.
- Turn the ignition to ON and look over the dash: most Mazdas of this age have no oil reminder to reset.
- If a wrench or maintenance message is showing and will not clear, have a shop reset it with a Mazda scan tool, since there is no button sequence for it.
Exact behavior varies by model and year on these older cars.
Sources: Mazda
Tire pressure (TPMS) light
- With the tires cold, set all four to the pressure on the label on the driver's door frame first, because starting with wrong pressures teaches the system the wrong baseline.
- Park somewhere safe and set the parking brake firmly, since the setup will not run while the car is moving.
- Turn the ignition to ON without starting off.
- Press and hold the TPMS set switch until the tire pressure warning light in the gauge cluster flashes twice and you hear a single beep.
- Release the switch; the two flashes and the beep mean the system has taken the new pressures as normal.
- Drive normally for a few minutes and make sure the warning light stays off.
The switch sits in the lower dash near the driver's knees on most models and in the glove box on some; the figure in your own owner's manual shows the exact spot.
- Set all four tires to the door frame label pressure first and recheck them when cold.
- Drive at a steady speed for ten minutes or so and see whether the light goes out on its own.
- If it stays on, stop guessing at buttons: the system is reporting a fault rather than low air.
- Have a tire shop or dealer read the system with a TPMS tool, register any new sensor IDs, and check for a dead sensor battery.
Sensor batteries usually give out somewhere past the seven year mark, and a dead one cannot be reset from inside the car.
Sources: Mazda
Worth knowing on a Mazda
Mazda counts down a distance to the next oil change rather than measuring oil condition, so reset it at every change even if no message has appeared. A tire pressure light that blinks for about a minute and then stays on means a system fault, not low air.