Reset a reminder light

How to reset the oil change and tire pressure lights on a Lexus

These two lights are reminders, not faults. Do the work first, then reset. Everything else on your dash is a warning, and clearing it does not fix anything.

Oil change or maintenance reminder

1Most models from about 2013 on, with a multi-information display and steering wheel meter switches
  1. Change the engine oil and filter first; the reset only clears the message, so run it after the service is finished.
  2. Turn the power switch to ON without starting the engine.
  3. Use the meter control switches on the steering wheel to bring up the Vehicle Settings menu on the multi-information display, then press in to enter it.
  4. Select Oil Maintenance to clear the oil reminder, or Scheduled Maintenance to clear the Maintenance Required message.
  5. Press and hold the select switch until the confirmation prompt appears.
  6. Choose Yes and confirm; the display reads that the data has been reset.

Lexus keeps Oil Maintenance and Scheduled Maintenance as two separate resets, so clear whichever message the car is actually showing.

2Older models with an analog odometer and a trip meter reset button, roughly 2012 and earlier
  1. Only reset the reminder after the oil change is complete.
  2. Turn the ignition on and use the display button to show Trip A in the odometer area.
  3. Turn the ignition off.
  4. Hold the trip meter reset button down and, still holding it, turn the ignition to ON without starting the engine.
  5. Keep holding until the maintenance light flashes and the trip display drops to zeros, then let go.
  6. Switch the ignition off and check that the message is gone.

Button names and locations vary by model and year on these cars, and some need the reset done through a dealer scan tool instead.

Sources: ManualsLib

Tire pressure (TPMS) light

1Models with a tire pressure warning reset switch under the steering column or in the lower dash
  1. Set all four tires, and the spare where it is monitored, to the cold pressure on the driver's door jamb sticker before anything else.
  2. Park somewhere safe and turn the power switch off; initialization will not run while the vehicle is moving.
  3. Turn the power switch to ON without starting the engine.
  4. Press and hold the tire pressure warning reset switch until the tire pressure warning light blinks slowly three times.
  5. Drive at about 25 mph or more for roughly ten minutes to finish the relearn.
2Newer models, including the GX, where the TPMS setting is in the multi-information display
  1. Correct every tire to the door-sticker cold pressure first, then start the vehicle.
  2. Use the arrow switches on the steering wheel to scroll the vehicle settings to the TPMS screen.
  3. Press and hold the select button in the middle of the arrow switches until the tire pressure warning light blinks three times.
  4. Let the engine run a few minutes or take a short drive for the light to go out.

You only need this after a rotation or a deliberate pressure change; a simple top-up usually clears itself after a short drive.

Sources: Capital One Auto Navigator · ManualsLib

Worth knowing on a Lexus

Lexus uses Toyota's systems, and the owner's manual treats the oil maintenance data, the Maintenance Required message and the tire pressure warning system as three separate things to reset. A tire pressure light that blinks for about a minute and then stays on is a sensor or system fault that needs a shop.

If the light comes straight back

Lexus models on the site

Button sequences vary by model year and trim. Your owner's manual is the final word for your exact vehicle. If a reminder will not clear after the service, something else is setting it.