Home › Warning lights › Stability control off light (ESC OFF)
Amber/yellow: check soon

Stability control off light (ESC OFF)

Also called: ESC OFF light, VSC OFF light, TCS OFF light, DSC OFF light, Traction control off light

How urgent? Check it when you can

What it means

The system that catches a skid and stops the wheels spinning is switched off. Either someone pressed the off button, or the car shut the system down itself because it found a fault.

An amber light in the instrument cluster, usually low down or off to one side. It is the car-with-skid-marks symbol plus the word OFF, and some makes skip the picture and just spell it out: ESC OFF, VSC OFF, TCS OFF, DSC OFF or StabiliTrak Off. A few cars show it as that symbol inside a circle with a line through it.

Can I keep driving?

Yes, the car still steers and brakes normally. But it will not help you if the back end slides, so take it easy in rain, snow and on gravel, and get it looked at if the light came on by itself.

If it's flashing or blinking: This light does not blink. The one that blinks for a second or two as you drive is the plain traction control light, and that is the system working properly to stop a wheel spinning. A steady OFF light means the system is not working at all.

What to do now

  1. Find the off button (often near the gear lever or left of the steering wheel) and press it to switch the system back on.
  2. If that does nothing, shut the engine off and restart; most cars turn the system back on at every start.
  3. Check whether the ABS, brake or check engine light is on as well, and tell the shop which ones.
  4. If the light will not go out, have the codes read from the brake and stability modules.

Common causes

  • The off button was pressed, on purpose or by accident
  • A drive mode or four-wheel-drive low range turned the system off
  • Wheel speed sensor fault
  • Steering angle sensor needs calibrating, often after battery or steering work
  • Mismatched, odd-size or badly worn tires, or a compact spare fitted
  • ABS or stability control module fault, or a blown fuse

Checks you can do yourself

Safe, no tools in most cases

Do these with the car parked and the engine off and cool. If anything looks or smells hot, wait.

1
Press the off button back on

Look for a button with the same car-and-skid-marks symbol, usually on the console near the gear lever or on the dash to the left of the steering wheel. With the car parked, press it and hold it for a second, then look at the dash. If the light goes out, someone had simply switched the system off.

2 minutes · None
2
Switch the engine off and restart

Turn the car off, wait about ten seconds, then start it again and watch the dash. Almost every car switches stability control back on by itself at each start. If the light comes back on with no one touching the button, the car has found a fault and is shutting the system down on its own.

2 minutes · None
3
Check the tires and look for the spare

With the car parked and the tires cold, check the pressure in all four with a gauge and set them to the numbers on the sticker in the driver's door opening. Then look at the tire sizes written on the sidewalls. A compact spare, a brand-new tire on one side, or a wrong size makes the wheels turn at different speeds, and some cars switch the system off when that happens.

10 minutes · Tire pressure gauge
4
Write down every other light that is on

Look over the whole dash and note which other warnings are lit, especially ABS, the red brake light and the check engine light. Then look up the symbol in the owner's manual index. Which lights come on together tells a shop a lot: ABS plus stability usually points to a wheel sensor, while a check engine light alongside often means the engine fault is what shut the system off.

10 minutes · Owner's manual

Step-by-step repair walkthroughs for the fixes below are on the way.

What not to do

  • Don't leave stability control switched off for everyday driving, and especially not in rain, snow or on ice.
  • Don't assume it is just the button if the light came on while you were driving along; that points to a fault.
  • Don't drive fast or accelerate hard with it on, because the car will not catch a slide for you.
  • Don't ignore an ABS or red brake warning that shows up with it; that is a braking problem, not just a switch.

What it usually turns out to be

Most likely first. Prices are typical US parts-and-labor totals for that repair, not a quote for your vehicle.

System switched off with the buttonPrice not verified

How you can tell No other warning lights are on, the car drives perfectly, and the light goes out as soon as you press the button again or restart the engine. Very common after someone leans on the console or uses a sport or snow mode.

The repair Press the button to turn the system back on. Nothing is broken and nothing needs paying for.

Failed wheel speed sensorPrice not verified

How you can tell The ABS light is usually on as well, the speedometer may flicker or drop to zero at low speed, and the stored code names one wheel, often starting with C00. Rust-belt cars get this most.

The repair The small sensor at that wheel is replaced and the codes cleared. The part is cheap; most of the bill is getting at it, and a rusted-in sensor takes longer.

Steering angle sensor out of calibration or failedPrice not verified

How you can tell It very often starts right after a dead battery, a battery change, an alignment, or steering or suspension work. The car drives fine but the system thinks the wheel is turned when it is straight.

The repair A shop recalibrates the sensor with a scan tool, with the car on level ground and the wheel centered. If the sensor itself has failed it is replaced, which means work at the steering column.

Mismatched tires or a compact spare fittedPrice not verified

How you can tell The light showed up right after a tire was changed, a spare went on, or one axle was replaced. The sidewall sizes do not match front to back, or one tire is nearly new next to three worn ones.

The repair Fit the correct matching size, replacing in pairs or as a set so the rolling sizes are close again, then clear the codes.

Brake light switch or low brake fluidPrice not verified

How you can tell Your brake lights stay on or do not light at all, cruise control will not set, or the brake fluid is below the line on the reservoir. The system uses the brake signal, so it drops out without it.

The repair The switch behind the brake pedal is replaced and adjusted, which is quick. Low fluid is topped up and the cause of the loss is traced, since brake fluid does not just disappear.

ABS or stability control module faultPrice not verified

How you can tell ABS, the stability light and the OFF light are all on together and the codes say the module is not answering or has an internal fault. Often an older car, sometimes after water got into a connector.

The repair The control unit is repaired or replaced and then coded to the car, which needs dealer-level equipment on most makes.

What a shop will do

First they check the obvious: is the button simply off, are the tires matched, is the brake fluid up. Then they plug in a scan tool that reads the brake and stability modules, not just engine codes, and look at each wheel speed sensor and the steering angle reading on a short test drive. That takes about an hour. An intermittent fault, or one that only appears over bumps, takes longer because they have to catch it happening.

How to reset this light

This is not a light you are meant to reset. If it is on because the button was pressed, pressing it again or simply restarting the car turns the system back on. If the car shut the system down because of a fault, clearing the code with a scanner fixes nothing: the light comes back as soon as the car sees the problem again, often within a few feet of driving off. Repair the sensor, the tires or the wiring and the light goes out by itself.

Button location and how long you hold it differ by make; a short press often turns off only wheel-spin control, a long press turns off the whole system.

Common questions

What does the stability control off light (esc off) mean?

The system that catches a skid and stops the wheels spinning is switched off. Either someone pressed the off button, or the car shut the system down itself because it found a fault.

Can I drive with the stability control off light (esc off) on?

Yes, the car still steers and brakes normally. But it will not help you if the back end slides, so take it easy in rain, snow and on gravel, and get it looked at if the light came on by itself.

How do I turn stability control back on?

Press the button with the car-and-skid-marks symbol, usually on the console near the gear lever or on the dash left of the wheel. On most cars a restart also turns it back on by itself. If the light stays on after both, the car is switching the system off because of a fault.

Is it safe to drive with the stability control off light on?

The car steers, brakes and stops normally, so short trips at sensible speeds are fine. What you lose is the help that catches a skid before you feel it, which matters most in rain, snow, ice and on loose gravel. Slow down and leave more room until it is fixed.

Will my car pass inspection with this light on?

It depends on where you live. In states that only do an emissions check, this light is not part of it. In states with a safety inspection, a lit brake or stability warning can fail, and it very often comes on together with the ABS light, which more states do check. Call your inspection station and ask.

Why did it come on after my battery died?

Losing power wipes the steering angle sensor's memory of where straight ahead is, so the car no longer trusts the system and shuts it off. Some cars relearn it if you drive slowly and turn the wheel fully each way; many need a shop to recalibrate it with a scan tool.

Does the light reset itself?

If it was just the button, yes, at the next engine start on nearly every car. If a fault turned the system off, no. It stays on, or returns within a mile or two of driving, until the actual problem is repaired.

Sources: Kia owner's manual · YourMechanic · Car Treatments

Not your light? These get mixed up with it

Symbols vary a little between makes. Your owner's manual shows the exact lights for your vehicle. This is a general guide, not a diagnosis.