P0231 Fuel Pump Secondary Circuit Low
What it means
The computer watches the power that goes out to the fuel pump. Here the voltage on the output side is lower than expected.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Listen for the fuel pump to hum for a couple of seconds when the key is turned on
- Inspect the fuel pump connector (often on top of the tank) and its wiring
- Check fuel pump voltage and ground at the pump
Signs you may notice
- Engine may crank but not start
- Stalling or sputtering while driving
- Check engine light on
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonWorn fuel pump drawing too much current
- CommonWiring to the pump shorted to ground
- PossibleCorroded connector at the fuel pump
- PossibleFaulty fuel pump relay or driver module
Typical repair once the cause is confirmed
Usually a wiring or connector repair at the tank, or a new fuel pump if it is worn out.
Common questions
What does P0231 mean?
The computer watches the power that goes out to the fuel pump. Here the voltage on the output side is lower than expected.
Can I drive with code P0231?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0231?
Common possibilities to test include: worn fuel pump drawing too much current; wiring to the pump shorted to ground; corroded connector at the fuel pump; faulty fuel pump relay or driver module. A shop should confirm the cause before replacing parts.