Home › Code lookup › P025D
Powertrain code · Fuel and air

P025D Fuel Pump Module Control Circuit High

How urgent? Get it checked in the next few days

What it means

Many newer vehicles run the fuel pump through a separate fuel pump control module, which takes orders from the engine computer. The command circuit reads higher than expected.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the fuel pump module and its connectors for corrosion
  2. Check the module's power, ground and command signal with a meter
  3. Listen for the fuel pump to run when the key is turned on

Signs you may notice

  • Engine may crank but not start
  • Stalling, sputtering or low power
  • Check engine light on

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonDamaged wiring or corroded connector between the engine computer and pump module
  • CommonFaulty fuel pump control module (often from corrosion)
  • PossibleFailing fuel pump
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Usually a new fuel pump control module or a wiring or connector repair.

Walk through it step by step: Engine stalls while driving →

Common questions

What does P025D mean?

Many newer vehicles run the fuel pump through a separate fuel pump control module, which takes orders from the engine computer. The command circuit reads higher than expected.

Can I drive with code P025D?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P025D?

Common possibilities to test include: damaged wiring or corroded connector between the engine computer and pump module; faulty fuel pump control module (often from corrosion); failing fuel pump; engine computer fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.