Home › Code lookup › P0314
Powertrain code · Ignition

P0314 Single Cylinder Misfire (Cylinder not Specified)

How urgent? Otherwise: Get it checked in the next few days

What it means

The computer detected that one cylinder is misfiring but can't tell which one. It is treated much like any other misfire code.

Can I keep driving?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away.

Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Use a scan tool's misfire counters to find which cylinder is acting up
  2. Inspect plugs and swap coils to see if the problem follows

Signs you may notice

  • Check engine light on, possibly flashing
  • Rough idle or shaking
  • Hesitation when accelerating

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWorn spark plug
  • CommonFailing ignition coil or plug wire
  • PossibleFaulty or clogged fuel injector
  • PossibleLow compression in one cylinder

Typical repair once the cause is confirmed

Find the weak cylinder, then usually replace its spark plug or coil.

Walk through it step by step: Engine sputters or misfires →

Common questions

What does P0314 mean?

The computer detected that one cylinder is misfiring but can't tell which one. It is treated much like any other misfire code.

Can I drive with code P0314?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away. Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0314?

Common possibilities to test include: worn spark plug; failing ignition coil or plug wire; faulty or clogged fuel injector; low compression in one cylinder. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.