P0315 Crankshaft Position System Variation Not Learned
What it means
The engine computer hasn't learned the small differences in the crankshaft sensor's signal that it needs to detect misfires accurately. This often happens after the sensor or computer is replaced.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Ask whether the crank sensor or computer was recently replaced
- Have a shop run the crankshaft variation relearn with a scan tool
Signs you may notice
- Check engine light on
- Usually no change in how the car drives
- Misfire monitoring may not run, so the car can fail an emissions test
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonCrankshaft variation relearn not done after replacing the crank sensor, engine computer or engine
- CommonRelearn procedure was attempted but did not finish
- PossibleFaulty crankshaft position sensor or damaged reluctor wheel
Typical repair once the cause is confirmed
A shop runs the crank position variation relearn with a capable scan tool; no parts are usually needed.
Where it shows up
- Mostly seen on GM vehicles after crank sensor or engine computer replacement
Known on these vehicles
Common questions
What does P0315 mean?
The engine computer hasn't learned the small differences in the crankshaft sensor's signal that it needs to detect misfires accurately. This often happens after the sensor or computer is replaced.
Can I drive with code P0315?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P0315?
Common possibilities to test include: crankshaft variation relearn not done after replacing the crank sensor, engine computer or engine; relearn procedure was attempted but did not finish; faulty crankshaft position sensor or damaged reluctor wheel. A shop should confirm the cause before replacing parts.