Home › Code lookup › P0316
Powertrain code · Ignition

P0316 Misfire Detected On Startup (First 1000 Revolutions)

How urgent? Otherwise: Get it checked in the next few days

What it means

The engine misfired in the first few seconds after starting, before it had warmed up. Moisture, a weak coil or a leaking injector are typical reasons.

Can I keep driving?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away.

Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check for single-cylinder misfire codes stored alongside it
  2. Inspect plugs for signs of coolant or oil
  3. Watch for coolant loss, which can point to a head gasket

Signs you may notice

  • Check engine light on
  • Rough or shaky running right after a cold start
  • Rough start that smooths out after a minute

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWorn spark plugs or weak ignition coils
  • PossibleMoisture or coolant getting into a cylinder
  • PossibleLeaking or sticking fuel injector
  • PossibleLow fuel pressure at startup

Typical repair once the cause is confirmed

Usually spark plugs and/or coils; coolant in a cylinder means a deeper repair such as a head gasket.

Walk through it step by step: Hard to start when cold →

Common questions

What does P0316 mean?

The engine misfired in the first few seconds after starting, before it had warmed up. Moisture, a weak coil or a leaking injector are typical reasons.

Can I drive with code P0316?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away. Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0316?

Common possibilities to test include: worn spark plugs or weak ignition coils; moisture or coolant getting into a cylinder; leaking or sticking fuel injector; low fuel pressure at startup. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.