P0322 Ignition/Distributor Engine Speed Input Circuit No Signal
What it means
The computer isn't getting any engine speed (RPM) signal from the distributor or ignition system. The engine may not start at all.
Can I keep driving?
If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away.
Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check whether the tachometer works while cranking
- Inspect wiring and connectors at the distributor or crank sensor
- Test the pickup sensor signal with a scope or meter
Signs you may notice
- Check engine light on
- Engine stalls, cuts out or won't start
- Tachometer may jump around or drop to zero
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFaulty crankshaft position or distributor pickup sensor
- CommonBad ignition module or igniter
- PossibleDamaged wiring or loose connector in the signal circuit
- PossibleWorn distributor shaft bushings causing an erratic signal
Typical repair once the cause is confirmed
Usually a new crank or distributor pickup sensor, ignition module, or a wiring repair.
Common questions
What does P0322 mean?
The computer isn't getting any engine speed (RPM) signal from the distributor or ignition system. The engine may not start at all.
Can I drive with code P0322?
If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away. Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0322?
Common possibilities to test include: faulty crankshaft position or distributor pickup sensor; bad ignition module or igniter; damaged wiring or loose connector in the signal circuit; worn distributor shaft bushings causing an erratic signal. A shop should confirm the cause before replacing parts.