P0326 Knock Sensor 1 Circuit Range/Performance (Bank 1 or Single Sensor)
What it means
The engine computer says the signal from knock sensor 1 is outside the range the computer expects for how the engine is running. The knock sensor listens for pinging, so the computer may play it safe by retarding timing, costing a little power and mileage.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the knock sensor connector and wiring for corrosion or breaks
- Check the sensor's resistance and mounting
Signs you may notice
- Check engine light on
- Slightly less power or sluggish acceleration
- Fuel economy may drop a little
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonDamaged, corroded or chafed knock sensor wiring
- CommonFailed knock sensor
- PossibleEngine mechanical noise or real knock confusing the sensor
- PossibleLoose knock sensor or wrong mounting torque
- PossibleEngine computer fault
Typical repair once the cause is confirmed
Usually a new knock sensor and/or a wiring pigtail repair. On many V engines the sensor sits under the intake manifold, which drives up labor.
Common questions
What does P0326 mean?
The engine computer says the signal from knock sensor 1 is outside the range the computer expects for how the engine is running. The knock sensor listens for pinging, so the computer may play it safe by retarding timing, costing a little power and mileage.
Can I drive with code P0326?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P0326?
Common possibilities to test include: damaged, corroded or chafed knock sensor wiring; failed knock sensor; engine mechanical noise or real knock confusing the sensor; loose knock sensor or wrong mounting torque. A shop should confirm the cause before replacing parts.