Home › Code lookup › P0327
Powertrain code · Engine

P0327 Knock Sensor 1 Circuit Low (Bank 1 or Single Sensor)

How urgent? Book a check when convenient

What it means

The engine computer says the signal voltage from knock sensor 1 is lower than it should be, usually from a wiring or sensor problem. The knock sensor listens for pinging, so the computer may play it safe by retarding timing, costing a little power and mileage.

Can I keep driving?

Usually you can keep driving and book a repair, though power and mileage may drop a little. Use the recommended fuel and avoid heavy loads. If you hear loud knocking or pinging or the engine loses power, ease off and get it checked soon, since real knock can damage the engine.

What to test before replacing parts

Check the knock sensor wiring for a short to ground or a break, inspect the connector, and test the sensor and its mounting before replacing it.

  1. Inspect the knock sensor connector and wiring for corrosion or breaks
  2. Check the sensor's resistance and mounting
  3. Rule out real engine knock from low-octane fuel or mechanical noise

Signs you may notice

  • Check engine light on
  • Slightly less power or sluggish acceleration
  • Fuel economy may drop a little
  • Possible pinging or knocking under load

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonShorted or broken knock sensor wiring
  • CommonFailed knock sensor
  • PossibleLoose knock sensor or wrong mounting torque
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Usually a new knock sensor and/or a wiring pigtail repair. On many V engines the sensor sits under the intake manifold, which drives up labor.

Repair costInsufficient verified pricing for this vehicle and repair
Replace knock sensor. Prepare an itemized shop request.

Where it shows up

  • Well known on GM 4.8, 5.3 and 6.0 V8 trucks and SUVs, where knock sensor wiring under the intake can corrode
Walk through it step by step: Check engine light on →

Common questions

What does P0327 mean?

The engine computer says the signal voltage from knock sensor 1 is lower than it should be, usually from a wiring or sensor problem. The knock sensor listens for pinging, so the computer may play it safe by retarding timing, costing a little power and mileage.

Can I drive with code P0327?

Usually you can keep driving and book a repair, though power and mileage may drop a little. Use the recommended fuel and avoid heavy loads. If you hear loud knocking or pinging or the engine loses power, ease off and get it checked soon, since real knock can damage the engine.

What causes P0327?

Common possibilities to test include: shorted or broken knock sensor wiring; failed knock sensor; loose knock sensor or wrong mounting torque; engine computer fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.