P0328 Knock Sensor 1 Circuit High (Bank 1 or Single Sensor)
What it means
The engine computer says the signal voltage from knock sensor 1 is higher than it should be, often from a wiring short or open circuit. The knock sensor listens for pinging, so the computer may play it safe by retarding timing, costing a little power and mileage.
Can I keep driving?
Usually you can keep driving and book a repair, though power and mileage may drop a little. Use the recommended fuel and avoid heavy loads. If you hear loud knocking or pinging or the engine loses power, ease off and get it checked soon, since real knock can damage the engine.
What to test before replacing parts
Check the knock sensor wiring for an open or a short to voltage, inspect the connector, and test the sensor and its mounting before replacing it.
- Inspect the knock sensor connector and wiring for corrosion or breaks
- Check the sensor's resistance and mounting
- Rule out real engine knock from low-octane fuel or mechanical noise
Signs you may notice
- Check engine light on
- Slightly less power or sluggish acceleration
- Fuel economy may drop a little
- Possible pinging or knocking under load
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonDamaged, corroded or chafed knock sensor wiring
- CommonFailed knock sensor
- PossibleLoose knock sensor or wrong mounting torque
- PossibleEngine computer fault
Typical repair once the cause is confirmed
Usually a new knock sensor and/or a wiring pigtail repair. On many V engines the sensor sits under the intake manifold, which drives up labor.
Where it shows up
- Frequently reported on Subaru boxer engines
Common questions
What does P0328 mean?
The engine computer says the signal voltage from knock sensor 1 is higher than it should be, often from a wiring short or open circuit. The knock sensor listens for pinging, so the computer may play it safe by retarding timing, costing a little power and mileage.
Can I drive with code P0328?
Usually you can keep driving and book a repair, though power and mileage may drop a little. Use the recommended fuel and avoid heavy loads. If you hear loud knocking or pinging or the engine loses power, ease off and get it checked soon, since real knock can damage the engine.
What causes P0328?
Common possibilities to test include: damaged, corroded or chafed knock sensor wiring; failed knock sensor; loose knock sensor or wrong mounting torque; engine computer fault. A shop should confirm the cause before replacing parts.