P032D Knock Sensor 3 Circuit High (Bank 1)
What it means
The engine computer says the signal voltage from knock sensor 3 is higher than it should be, often from a wiring short or open circuit. The knock sensor listens for pinging, so the computer may play it safe by retarding timing, costing a little power and mileage.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the knock sensor connector and wiring for corrosion or breaks
- Check the sensor's resistance and mounting
Signs you may notice
- Check engine light on
- Slightly less power or sluggish acceleration
- Fuel economy may drop a little
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonDamaged, corroded or chafed knock sensor wiring
- CommonFailed knock sensor
- PossibleLoose knock sensor or wrong mounting torque
- PossibleEngine computer fault
Typical repair once the cause is confirmed
Usually a new knock sensor and/or a wiring pigtail repair. On many V engines the sensor sits under the intake manifold, which drives up labor.
Common questions
What does P032D mean?
The engine computer says the signal voltage from knock sensor 3 is higher than it should be, often from a wiring short or open circuit. The knock sensor listens for pinging, so the computer may play it safe by retarding timing, costing a little power and mileage.
Can I drive with code P032D?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P032D?
Common possibilities to test include: damaged, corroded or chafed knock sensor wiring; failed knock sensor; loose knock sensor or wrong mounting torque; engine computer fault. A shop should confirm the cause before replacing parts.