Home › Code lookup › P0341
Powertrain code · Engine

P0341 Camshaft Position Sensor "A" Circuit Range/Performance (Bank 1 or Single Sensor)

How urgent? Get it checked in the next few days

What it means

The engine computer says the signal doesn't match what it expects from camshaft position sensor A (bank 1 or single sensor). This sensor tracks the camshaft, which on most engines is the intake cam, so the computer can time fuel and spark.

Can I keep driving?

If it starts and runs smoothly, you can usually drive gently to a shop soon. If it stalls, runs rough or loses power, limit driving and avoid highways. If you hear rattling or the engine runs very rough, stop; a jumped timing belt or chain can cause serious engine damage.

What to test before replacing parts

Verify bank 1 cam-to-crank timing with a scope or scan tool, check for a stretched chain or cam phaser fault, and inspect the wiring before replacing the cam sensor.

  1. Inspect the sensor connector for oil, corrosion or a broken lock tab
  2. Check battery and charging voltage
  3. Compare cam and crank signals with a scan tool or scope to check timing

Signs you may notice

  • Check engine light on
  • Long cranking or hard starting
  • Stalling, rough running or reduced power
  • Poor fuel economy

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonTiming chain or belt stretched, jumped, or a cam phaser problem
  • CommonDamaged wiring or loose, oil-soaked connector
  • PossibleFailed camshaft position sensor
  • PossibleWeak battery or charging voltage during cranking
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Start with the sensor and wiring, but this code often points to a stretched timing chain or cam phaser issue, which is a bigger job.

Repair costInsufficient verified pricing for this vehicle and repair
Replace camshaft position sensor. Prepare an itemized shop request.

Known on these vehicles

Walk through it step by step: Check engine light on →

Common questions

What does P0341 mean?

The engine computer says the signal doesn't match what it expects from camshaft position sensor A (bank 1 or single sensor). This sensor tracks the camshaft, which on most engines is the intake cam, so the computer can time fuel and spark.

Can I drive with code P0341?

If it starts and runs smoothly, you can usually drive gently to a shop soon. If it stalls, runs rough or loses power, limit driving and avoid highways. If you hear rattling or the engine runs very rough, stop; a jumped timing belt or chain can cause serious engine damage.

What causes P0341?

Common possibilities to test include: timing chain or belt stretched, jumped, or a cam phaser problem; damaged wiring or loose, oil-soaked connector; failed camshaft position sensor; weak battery or charging voltage during cranking. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.