Home › Code lookup › P0346
Powertrain code · Engine

P0346 Camshaft Position Sensor "A" Circuit Range/Performance (Bank 2)

How urgent? Otherwise: Get it checked in the next few days

What it means

The engine computer says the signal doesn't match what it expects from camshaft position sensor A (bank 2). This sensor tracks the camshaft, which on most engines is the intake cam, so the computer can time fuel and spark.

Can I keep driving?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away.

Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the sensor connector for oil, corrosion or a broken lock tab
  2. Compare cam and crank signals with a scan tool or scope to check timing

Signs you may notice

  • Check engine light on
  • Long cranking or hard starting
  • Stalling, rough running or reduced power

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonTiming chain or belt stretched, jumped, or a cam phaser problem
  • CommonDamaged wiring or loose, oil-soaked connector
  • PossibleFailed camshaft position sensor
  • PossibleWeak battery or charging voltage during cranking
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Start with the sensor and wiring, but this code often points to a stretched timing chain or cam phaser issue, which is a bigger job.

Walk through it step by step: Check engine light on →

Common questions

What does P0346 mean?

The engine computer says the signal doesn't match what it expects from camshaft position sensor A (bank 2). This sensor tracks the camshaft, which on most engines is the intake cam, so the computer can time fuel and spark.

Can I drive with code P0346?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away. Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0346?

Common possibilities to test include: timing chain or belt stretched, jumped, or a cam phaser problem; damaged wiring or loose, oil-soaked connector; failed camshaft position sensor; weak battery or charging voltage during cranking. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.