Home › Code lookup › P0350
Powertrain code · Ignition

P0350 Ignition Coil Primary/Secondary Circuit

How urgent? Otherwise: Get it checked in the next few days

What it means

The engine computer found a problem in an ignition coil circuit but isn't naming a specific coil. A bad coil circuit usually causes a misfire.

Can I keep driving?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away.

Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look for misfire codes that point to a specific cylinder
  2. Inspect coil connectors and check power at each coil

Signs you may notice

  • Check engine light on
  • Misfire, rough idle or shaking
  • Loss of power or hesitation

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed ignition coil
  • CommonDamaged coil wiring or connector
  • PossibleProblem in the shared power feed to the coils
  • PossibleEngine computer coil driver fault

Typical repair once the cause is confirmed

Find the faulty coil or wiring and repair or replace it.

Walk through it step by step: Engine sputters or misfires →

Common questions

What does P0350 mean?

The engine computer found a problem in an ignition coil circuit but isn't naming a specific coil. A bad coil circuit usually causes a misfire.

Can I drive with code P0350?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away. Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0350?

Common possibilities to test include: failed ignition coil; damaged coil wiring or connector; problem in the shared power feed to the coils; engine computer coil driver fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.