P0351 Ignition Coil "A" Primary/Secondary Circuit
What it means
The engine computer found an electrical problem with ignition coil A (on most engines, the coil for cylinder 1). That cylinder will likely misfire.
Can I keep driving?
If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away.
Otherwise: If the check engine light is flashing or the engine shakes, slow down and get it checked right away; a dead coil causes a misfire that can overheat the catalytic converter. If the light is steady and it runs only a little rough, drive gently to a shop within a few days.
What to test before replacing parts
Check the wiring and connector at coil A, test its control wire back to the computer, check its spark plug, and swap the coil with another to see if the fault follows before replacing parts.
- Swap the coil with another cylinder and see if the code follows it
- Inspect the connector and wiring for damage, oil or corrosion
- Check power and the control signal at the coil connector
Signs you may notice
- Check engine light on, possibly flashing
- Misfire, rough idle or shaking
- Hesitation or loss of power when accelerating
- Worse fuel economy
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed ignition coil A
- CommonDamaged wiring or loose connector at the coil
- PossibleWorn spark plug overloading the coil
- PossibleOpen or shorted coil control wire back to the computer
- PossibleEngine computer coil driver fault
Typical repair once the cause is confirmed
Usually a new ignition coil, often with a fresh spark plug; repair the wiring if the coil tests good.
Common questions
What does P0351 mean?
The engine computer found an electrical problem with ignition coil A (on most engines, the coil for cylinder 1). That cylinder will likely misfire.
Can I drive with code P0351?
If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away. Otherwise: If the check engine light is flashing or the engine shakes, slow down and get it checked right away; a dead coil causes a misfire that can overheat the catalytic converter. If the light is steady and it runs only a little rough, drive gently to a shop within a few days.
What causes P0351?
Common possibilities to test include: failed ignition coil a; damaged wiring or loose connector at the coil; worn spark plug overloading the coil; open or shorted coil control wire back to the computer. A shop should confirm the cause before replacing parts.