Home › Code lookup › P0356
Powertrain code · Ignition

P0356 Ignition Coil "F" Primary/Secondary Circuit

How urgent? Otherwise: Get it checked in the next few days

What it means

The engine computer found an electrical problem with ignition coil F (on most engines, the coil for cylinder 6). That cylinder will likely misfire.

Can I keep driving?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away.

Otherwise: If the check engine light is flashing or the engine shakes, slow down and get it checked right away; a dead coil causes a misfire that can overheat the catalytic converter. If the light is steady and it runs only a little rough, drive gently to a shop within a few days.

What to test before replacing parts

Check the wiring and connector at coil F, test its control wire back to the computer, check its spark plug, and swap the coil with another to see if the fault follows before replacing parts.

  1. Swap the coil with another cylinder and see if the code follows it
  2. Inspect the connector and wiring for damage, oil or corrosion
  3. Check power and the control signal at the coil connector

Signs you may notice

  • Check engine light on, possibly flashing
  • Misfire, rough idle or shaking
  • Hesitation or loss of power when accelerating
  • Worse fuel economy

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed ignition coil F
  • CommonDamaged wiring or loose connector at the coil
  • PossibleWorn spark plug overloading the coil
  • PossibleOpen or shorted coil control wire back to the computer
  • PossibleEngine computer coil driver fault

Typical repair once the cause is confirmed

Usually a new ignition coil, often with a fresh spark plug; repair the wiring if the coil tests good.

Repair costInsufficient verified pricing for this vehicle and repair
Replace ignition coil. Prepare an itemized shop request.
Walk through it step by step: Engine sputters or misfires →

Common questions

What does P0356 mean?

The engine computer found an electrical problem with ignition coil F (on most engines, the coil for cylinder 6). That cylinder will likely misfire.

Can I drive with code P0356?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away. Otherwise: If the check engine light is flashing or the engine shakes, slow down and get it checked right away; a dead coil causes a misfire that can overheat the catalytic converter. If the light is steady and it runs only a little rough, drive gently to a shop within a few days.

What causes P0356?

Common possibilities to test include: failed ignition coil f; damaged wiring or loose connector at the coil; worn spark plug overloading the coil; open or shorted coil control wire back to the computer. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.