P0357 Ignition Coil "G" Primary/Secondary Circuit
What it means
The engine computer found an electrical problem with ignition coil G (on most engines, the coil for cylinder 7). That cylinder will likely misfire.
Can I keep driving?
If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away.
Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Swap the coil with another cylinder and see if the code follows it
- Inspect the connector and wiring for damage, oil or corrosion
Signs you may notice
- Check engine light on, possibly flashing
- Misfire, rough idle or shaking
- Hesitation or loss of power when accelerating
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed ignition coil G
- CommonDamaged wiring or loose connector at the coil
- PossibleWorn spark plug overloading the coil
- PossibleOpen or shorted coil control wire back to the computer
- PossibleEngine computer coil driver fault
Typical repair once the cause is confirmed
Usually a new ignition coil, often with a fresh spark plug; repair the wiring if the coil tests good.
Common questions
What does P0357 mean?
The engine computer found an electrical problem with ignition coil G (on most engines, the coil for cylinder 7). That cylinder will likely misfire.
Can I drive with code P0357?
If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away. Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0357?
Common possibilities to test include: failed ignition coil g; damaged wiring or loose connector at the coil; worn spark plug overloading the coil; open or shorted coil control wire back to the computer. A shop should confirm the cause before replacing parts.