Home › Code lookup › P0361
Powertrain code · Ignition

P0361 Ignition Coil "K" Primary/Secondary Circuit

How urgent? Otherwise: Get it checked in the next few days

What it means

The engine computer found an electrical problem with ignition coil K (on most engines, the coil for cylinder 11). That cylinder will likely misfire.

Can I keep driving?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away.

Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Swap the coil with another cylinder and see if the code follows it
  2. Inspect the connector and wiring for damage, oil or corrosion

Signs you may notice

  • Check engine light on, possibly flashing
  • Misfire, rough idle or shaking
  • Hesitation or loss of power when accelerating

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed ignition coil K
  • CommonDamaged wiring or loose connector at the coil
  • PossibleWorn spark plug overloading the coil
  • PossibleOpen or shorted coil control wire back to the computer
  • PossibleEngine computer coil driver fault

Typical repair once the cause is confirmed

Usually a new ignition coil, often with a fresh spark plug; repair the wiring if the coil tests good.

Walk through it step by step: Engine sputters or misfires →

Common questions

What does P0361 mean?

The engine computer found an electrical problem with ignition coil K (on most engines, the coil for cylinder 11). That cylinder will likely misfire.

Can I drive with code P0361?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away. Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0361?

Common possibilities to test include: failed ignition coil k; damaged wiring or loose connector at the coil; worn spark plug overloading the coil; open or shorted coil control wire back to the computer. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.