P0365 Camshaft Position Sensor "B" Circuit (Bank 1)
What it means
The engine computer says there's a fault in the circuit for camshaft position sensor B (bank 1). This sensor tracks the camshaft, which on most engines is the exhaust cam, so the computer can time fuel and spark.
Can I keep driving?
If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away.
Otherwise: If it starts and runs smoothly, you can usually drive gently to a shop soon. If it stalls, runs rough or loses power, limit driving and avoid highways. If you hear rattling or the engine runs very rough, stop; a jumped timing belt or chain can cause serious engine damage.
What to test before replacing parts
Check the bank 1 "B" cam sensor signal and wiring and battery voltage while cranking, and verify cam-to-crank timing before replacing the sensor; a stretched or jumped timing chain or belt can set this code.
- Inspect the sensor connector for oil, corrosion or a broken lock tab
- Check battery and charging voltage
- Compare cam and crank signals with a scan tool or scope to check timing
Signs you may notice
- Check engine light on
- Long cranking or hard starting
- Stalling, rough running or reduced power
- Poor fuel economy
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed camshaft position sensor
- CommonDamaged wiring or loose, oil-soaked connector
- PossibleTiming belt or chain stretched or jumped a tooth
- PossibleWeak battery or charging voltage during cranking
- PossibleEngine computer fault
Typical repair once the cause is confirmed
Usually a new camshaft position sensor or a wiring repair; if the timing is off, the timing belt or chain needs attention.
Common questions
What does P0365 mean?
The engine computer says there's a fault in the circuit for camshaft position sensor B (bank 1). This sensor tracks the camshaft, which on most engines is the exhaust cam, so the computer can time fuel and spark.
Can I drive with code P0365?
If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away. Otherwise: If it starts and runs smoothly, you can usually drive gently to a shop soon. If it stalls, runs rough or loses power, limit driving and avoid highways. If you hear rattling or the engine runs very rough, stop; a jumped timing belt or chain can cause serious engine damage.
What causes P0365?
Common possibilities to test include: failed camshaft position sensor; damaged wiring or loose, oil-soaked connector; timing belt or chain stretched or jumped a tooth; weak battery or charging voltage during cranking. A shop should confirm the cause before replacing parts.