Home › Code lookup › P0367
Powertrain code · Engine

P0367 Camshaft Position Sensor "B" Circuit Low (Bank 1)

How urgent? Otherwise: Get it checked in the next few days

What it means

The engine computer says the signal voltage is too low from camshaft position sensor B (bank 1). This sensor tracks the camshaft, which on most engines is the exhaust cam, so the computer can time fuel and spark.

Can I keep driving?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away.

Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the sensor connector for oil, corrosion or a broken lock tab
  2. Compare cam and crank signals with a scan tool or scope to check timing

Signs you may notice

  • Check engine light on
  • Long cranking or hard starting
  • Stalling, rough running or reduced power

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed camshaft position sensor
  • CommonSignal or power wire shorted to ground or broken
  • PossibleTiming belt or chain stretched or jumped a tooth
  • PossibleWeak battery or charging voltage during cranking
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Usually a new camshaft position sensor or a wiring repair; if the timing is off, the timing belt or chain needs attention.

Walk through it step by step: Check engine light on →

Common questions

What does P0367 mean?

The engine computer says the signal voltage is too low from camshaft position sensor B (bank 1). This sensor tracks the camshaft, which on most engines is the exhaust cam, so the computer can time fuel and spark.

Can I drive with code P0367?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away. Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0367?

Common possibilities to test include: failed camshaft position sensor; signal or power wire shorted to ground or broken; timing belt or chain stretched or jumped a tooth; weak battery or charging voltage during cranking. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.