Home › Code lookup › P0374
Powertrain code · Engine

P0374 Timing Reference High Resolution Signal A No Pulses

How urgent? Get it checked in the next few days

What it means

The fine-detail timing signal A that the computer uses to time spark and fuel precisely isn't arriving at all. It usually comes from a crankshaft or distributor sensor.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect sensor wiring and grounds, and keep ignition wires away from it
  2. Test the sensor signal with a scope

Signs you may notice

  • Check engine light on
  • Stalling, misfire or rough running
  • Hard starting or no start

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty crankshaft or distributor position sensor
  • CommonDamaged wiring or connector in the signal circuit
  • PossibleElectrical interference from ignition wires, an aftermarket accessory or a bad ground
  • PossibleDamaged tone ring or sensor disc
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Usually a new crank or distributor sensor, or a wiring or ground repair.

Walk through it step by step: Car won't start →

Common questions

What does P0374 mean?

The fine-detail timing signal A that the computer uses to time spark and fuel precisely isn't arriving at all. It usually comes from a crankshaft or distributor sensor.

Can I drive with code P0374?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0374?

Common possibilities to test include: faulty crankshaft or distributor position sensor; damaged wiring or connector in the signal circuit; electrical interference from ignition wires, an aftermarket accessory or a bad ground; damaged tone ring or sensor disc. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.