Home › Code lookup › P0382
Powertrain code · Ignition

P0382 Glow Plug/Heater Circuit "B"

How urgent? Get it checked in the next few days

What it means

On a diesel, the computer found a problem in glow plug (or intake heater) circuit B. Glow plugs heat the cylinders so the engine starts easily, so expect hard cold starts.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Test each glow plug's resistance to find any that have burned out
  2. Inspect glow plug wiring, connectors and fuses
  3. Check that the control module or relay powers the plugs when commanded

Signs you may notice

  • Check engine light and often a glow plug warning light
  • Hard starting or long cranking in cold weather
  • White smoke and rough running right after a cold start

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonOne or more failed glow plugs
  • CommonFaulty glow plug control module or relay
  • CommonDamaged, corroded or loose glow plug wiring
  • PossibleBlown fuse or fusible link in the glow plug circuit
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Most often replacing failed glow plugs, the glow plug control module, or damaged wiring.

Walk through it step by step: Hard to start when cold →

Common questions

What does P0382 mean?

On a diesel, the computer found a problem in glow plug (or intake heater) circuit B. Glow plugs heat the cylinders so the engine starts easily, so expect hard cold starts.

Can I drive with code P0382?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0382?

Common possibilities to test include: one or more failed glow plugs; faulty glow plug control module or relay; damaged, corroded or loose glow plug wiring; blown fuse or fusible link in the glow plug circuit. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.