Home › Code lookup › P0383
Powertrain code · Ignition

P0383 Glow Plug Control Module Control Circuit Low

How urgent? Get it checked in the next few days

What it means

On a diesel, the signal the engine computer uses to command the glow plug control module is reading too low, so the glow plugs may not switch on.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect glow plug wiring, connectors and fuses
  2. Check that the control module or relay powers the plugs when commanded

Signs you may notice

  • Check engine light and often a glow plug warning light
  • Hard starting or long cranking in cold weather
  • White smoke and rough running right after a cold start

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonDamaged or shorted wire between the engine computer and glow plug module
  • CommonFaulty glow plug control module
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Repair the control wiring or replace the glow plug control module.

Walk through it step by step: Hard to start when cold →

Common questions

What does P0383 mean?

On a diesel, the signal the engine computer uses to command the glow plug control module is reading too low, so the glow plugs may not switch on.

Can I drive with code P0383?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0383?

Common possibilities to test include: damaged or shorted wire between the engine computer and glow plug module; faulty glow plug control module; engine computer fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.