Home › Code lookup › P0391
Powertrain code · Engine

P0391 Camshaft Position Sensor "B" Circuit Range/Performance (Bank 2)

How urgent? Get it checked in the next few days

What it means

The engine computer says the signal doesn't match what it expects from camshaft position sensor B on bank 2. On most engines this sensor tracks the exhaust camshaft so the computer can time fuel, spark and valve timing.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the sensor connector for oil, corrosion or a broken lock tab
  2. Compare cam and crank signals with a scan tool or scope to check timing

Signs you may notice

  • Check engine light on
  • Long cranking or hard starting
  • Stalling, rough running or reduced power

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonTiming chain or belt stretched, jumped, or a cam phaser problem
  • CommonDamaged wiring or loose, oil-soaked connector
  • PossibleFailed camshaft position sensor
  • PossibleWeak battery or charging voltage during cranking
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Start with the sensor and wiring, but this code often points to a stretched timing chain or cam phaser issue, which is a bigger job.

Walk through it step by step: Check engine light on →

Common questions

What does P0391 mean?

The engine computer says the signal doesn't match what it expects from camshaft position sensor B on bank 2. On most engines this sensor tracks the exhaust camshaft so the computer can time fuel, spark and valve timing.

Can I drive with code P0391?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0391?

Common possibilities to test include: timing chain or belt stretched, jumped, or a cam phaser problem; damaged wiring or loose, oil-soaked connector; failed camshaft position sensor; weak battery or charging voltage during cranking. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.