Home › Code lookup › P0392
Powertrain code · Engine

P0392 Camshaft Position Sensor "B" Circuit Low (Bank 2)

How urgent? Get it checked in the next few days

What it means

The engine computer says the signal voltage is too low from camshaft position sensor B on bank 2. On most engines this sensor tracks the exhaust camshaft so the computer can time fuel, spark and valve timing.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the sensor connector for oil, corrosion or a broken lock tab
  2. Compare cam and crank signals with a scan tool or scope to check timing

Signs you may notice

  • Check engine light on
  • Long cranking or hard starting
  • Stalling, rough running or reduced power

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed camshaft position sensor
  • CommonDamaged wiring or loose, oil-soaked connector
  • PossibleTiming belt or chain stretched or jumped a tooth
  • PossibleWeak battery or charging voltage during cranking
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Usually a new camshaft position sensor or a wiring repair; if the timing is off, the timing chain or belt needs attention.

Walk through it step by step: Check engine light on →

Common questions

What does P0392 mean?

The engine computer says the signal voltage is too low from camshaft position sensor B on bank 2. On most engines this sensor tracks the exhaust camshaft so the computer can time fuel, spark and valve timing.

Can I drive with code P0392?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0392?

Common possibilities to test include: failed camshaft position sensor; damaged wiring or loose, oil-soaked connector; timing belt or chain stretched or jumped a tooth; weak battery or charging voltage during cranking. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.