Home › Code lookup › P0533
Powertrain code · Body

P0533 A/C Refrigerant Pressure Sensor "A" Circuit High

How urgent? Book a check when convenient

What it means

The signal from the A/C refrigerant pressure sensor is higher than it should ever be, which usually points to a broken wire, bad ground or a failed sensor. This part tells the computer the pressure in the A/C system.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring and connector for broken wires or corrosion
  2. Check reference voltage and ground at the connector with a meter

Signs you may notice

  • A/C blowing warm or cutting in and out
  • Check engine light on

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonBroken wire or poor ground in the sensor circuit
  • CommonFaulty A/C refrigerant pressure sensor
  • PossibleUnplugged or corroded connector
  • PossibleSignal wire shorted to a voltage source

Typical repair once the cause is confirmed

Usually a wiring or connector repair, or a new A/C refrigerant pressure sensor if it tests bad.

Walk through it step by step: A/C blows warm air →

Common questions

What does P0533 mean?

The signal from the A/C refrigerant pressure sensor is higher than it should ever be, which usually points to a broken wire, bad ground or a failed sensor. This part tells the computer the pressure in the A/C system.

Can I drive with code P0533?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P0533?

Common possibilities to test include: broken wire or poor ground in the sensor circuit; faulty a/c refrigerant pressure sensor; unplugged or corroded connector; signal wire shorted to a voltage source. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.