Home › Code lookup › P0537
Powertrain code · Body

P0537 A/C Evaporator Temperature Sensor Circuit Low

How urgent? Book a check when convenient

What it means

The signal from the A/C evaporator temperature sensor is lower than it should ever be, which usually points to a wiring short or a failed sensor. This part tells the computer how cold the A/C evaporator is so it does not freeze up.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring and connector for rubbing, damage or corrosion
  2. Check reference voltage and ground at the connector with a meter

Signs you may notice

  • A/C blowing warm or cutting out
  • A/C may ice up and lose airflow

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSignal wire shorted to ground
  • CommonFaulty A/C evaporator temperature sensor
  • PossibleCorroded or water-damaged connector
  • PossibleProblem with the sensor's reference voltage supply

Typical repair once the cause is confirmed

Usually a wiring or connector repair, or a new A/C evaporator temperature sensor if it tests bad.

Walk through it step by step: A/C blows warm air →

Common questions

What does P0537 mean?

The signal from the A/C evaporator temperature sensor is lower than it should ever be, which usually points to a wiring short or a failed sensor. This part tells the computer how cold the A/C evaporator is so it does not freeze up.

Can I drive with code P0537?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P0537?

Common possibilities to test include: signal wire shorted to ground; faulty a/c evaporator temperature sensor; corroded or water-damaged connector; problem with the sensor's reference voltage supply. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.