P2203 NOx Sensor Circuit High Input Bank 1
What it means
The signal from the NOx sensor (bank 1) is higher than the computer expects. This sensor measures nitrogen oxide pollution in diesel exhaust so the exhaust treatment system can adjust. An open (broken) wire, a bad ground or a failed sensor is the usual reason.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Make sure the NOx sensor connector is fully plugged in and clean
- Check the sensor ground and signal wire for an open circuit
Signs you may notice
- Check engine light on
- Possible emissions warning or reduced power on some diesels
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonOpen or broken signal or ground wire
- CommonUnplugged or corroded connector
- PossibleFailed NOx sensor
- PossibleWire shorted to a power source
Typical repair once the cause is confirmed
Repair any damaged wiring or connector first; if the circuit tests good, replace the NOx sensor.
Common questions
What does P2203 mean?
The signal from the NOx sensor (bank 1) is higher than the computer expects. This sensor measures nitrogen oxide pollution in diesel exhaust so the exhaust treatment system can adjust. An open (broken) wire, a bad ground or a failed sensor is the usual reason.
Can I drive with code P2203?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2203?
Common possibilities to test include: open or broken signal or ground wire; unplugged or corroded connector; failed nox sensor; wire shorted to a power source. A shop should confirm the cause before replacing parts.