Home › Code lookup › P2207
Powertrain code · Emissions

P2207 NOx Sensor Heater Control Circuit High Bank 1

How urgent? Get it checked in the next few days

What it means

The control circuit for the NOx sensor heater (bank 1) is reading high voltage. This part heats the NOx sensor so it can read accurately. A wire shorted to power, an open circuit or a failed part is the usual reason.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the NOx sensor wiring for shorts to other wires
  2. Measure the NOx sensor resistance and compare with spec

Signs you may notice

  • Check engine light on
  • Possible emissions warning or reduced power on some diesels

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed NOx sensor (heater is built in)
  • CommonControl wire shorted to a power source
  • PossibleOpen circuit or corroded connector
  • PossibleEngine computer driver problem (rare)

Typical repair once the cause is confirmed

Repair any wiring fault first; if the wiring tests good, replace the NOx sensor (heater is built in).

Repair costInsufficient verified pricing for this vehicle and repair

Common questions

What does P2207 mean?

The control circuit for the NOx sensor heater (bank 1) is reading high voltage. This part heats the NOx sensor so it can read accurately. A wire shorted to power, an open circuit or a failed part is the usual reason.

Can I drive with code P2207?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2207?

Common possibilities to test include: failed nox sensor (heater is built in); control wire shorted to a power source; open circuit or corroded connector; engine computer driver problem (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.