Home › Code lookup › P2208
Powertrain code · Emissions

P2208 NOx Sensor Heater Sense Circuit Bank 1

How urgent? Get it checked in the next few days

What it means

The engine computer has found a problem in the circuit for the NOx sensor heater (bank 1), which heats the NOx sensor so it can read accurately. It usually points to wiring, a connector or the sensor itself.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the NOx sensor connector and wiring for damage or corrosion
  2. Check the sensor power, ground and signal with a meter

Signs you may notice

  • Check engine light on
  • Possible emissions warning or reduced power on some diesels

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty NOx sensor (heater is built in)
  • CommonDamaged, corroded or unplugged connector
  • PossibleBroken or chafed wiring
  • PossibleEngine computer problem (rare)

Typical repair once the cause is confirmed

Repair any damaged wiring or connector first; if the circuit tests good, replace the NOx sensor (heater is built in).

Repair costInsufficient verified pricing for this vehicle and repair

Common questions

What does P2208 mean?

The engine computer has found a problem in the circuit for the NOx sensor heater (bank 1), which heats the NOx sensor so it can read accurately. It usually points to wiring, a connector or the sensor itself.

Can I drive with code P2208?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2208?

Common possibilities to test include: faulty nox sensor (heater is built in); damaged, corroded or unplugged connector; broken or chafed wiring; engine computer problem (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.