P2206 NOx Sensor Heater Control Circuit Low Bank 1
What it means
The control circuit for the NOx sensor heater (bank 1) is reading low voltage. This part heats the NOx sensor so it can read accurately. A wire shorted to ground or a shorted part is the usual reason.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the NOx sensor wiring for rubbed-through insulation
- Measure the NOx sensor resistance and compare with spec
Signs you may notice
- Check engine light on
- Possible emissions warning or reduced power on some diesels
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonControl wire shorted to ground
- CommonInternally shorted NOx sensor (heater is built in)
- PossibleDamaged connector
- PossibleEngine computer driver problem (rare)
Typical repair once the cause is confirmed
Repair any wiring fault first; if the wiring tests good, replace the NOx sensor (heater is built in).
Common questions
What does P2206 mean?
The control circuit for the NOx sensor heater (bank 1) is reading low voltage. This part heats the NOx sensor so it can read accurately. A wire shorted to ground or a shorted part is the usual reason.
Can I drive with code P2206?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2206?
Common possibilities to test include: control wire shorted to ground; internally shorted nox sensor (heater is built in); damaged connector; engine computer driver problem (rare). A shop should confirm the cause before replacing parts.