Home › Code lookup › P2505
Powertrain code · Computer

P2505 ECM/PCM Power Input Signal

How urgent? Get it checked in the next few days

What it means

The computer is watching the power supply circuit to the engine computer and has spotted an electrical fault. The engine computer needs a steady supply voltage to run everything else correctly.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the connector and wiring for the power supply circuit to the engine computer, checking for damage, corrosion or a loose fit
  2. Check power, ground and signal with a meter
  3. Clear the code and see if it comes back

Signs you may notice

  • Check engine light on
  • Hard starting or stalling in some cases
  • Other electrical codes may appear

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWeak battery or loose, corroded battery terminals
  • CommonUnplugged, loose or corroded connector at the engine computer power relay
  • CommonBroken or chafed wire in the power supply circuit to the engine computer
  • CommonFailed engine computer power relay
  • PossibleMissing reference voltage or ground from the computer

Typical repair once the cause is confirmed

Fix the battery, cable or wiring fault first; replace the power relay or fuse if bad. The engine computer itself is rarely the cause.

Walk through it step by step: Check engine light on →

Common questions

What does P2505 mean?

The computer is watching the power supply circuit to the engine computer and has spotted an electrical fault. The engine computer needs a steady supply voltage to run everything else correctly.

Can I drive with code P2505?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2505?

Common possibilities to test include: weak battery or loose, corroded battery terminals; unplugged, loose or corroded connector at the engine computer power relay; broken or chafed wire in the power supply circuit to the engine computer; failed engine computer power relay. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.