P2507 ECM/PCM Power Input Signal Low
What it means
The computer is watching the power supply circuit to the engine computer and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. The engine computer needs a steady supply voltage to run everything else correctly.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the wiring in the power supply circuit to the engine computer for rubbed-through insulation touching metal
- Check the wiring for a short to ground with a meter
- Clear the code and see if it returns right away
Signs you may notice
- Check engine light on
- Hard starting or stalling in some cases
- Other electrical codes may appear
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonWeak battery or loose, corroded battery terminals
- CommonSignal wire in the power supply circuit to the engine computer shorted to ground or open
- CommonFailed engine computer power relay
- PossibleCorroded or loose connector
- PossibleControl module fault (rare)
Typical repair once the cause is confirmed
Fix the battery, cable or wiring fault first; replace the power relay or fuse if bad. The engine computer itself is rarely the cause.
Common questions
What does P2507 mean?
The computer is watching the power supply circuit to the engine computer and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. The engine computer needs a steady supply voltage to run everything else correctly.
Can I drive with code P2507?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2507?
Common possibilities to test include: weak battery or loose, corroded battery terminals; signal wire in the power supply circuit to the engine computer shorted to ground or open; failed engine computer power relay; corroded or loose connector. A shop should confirm the cause before replacing parts.