Home › Code lookup › P2508
Powertrain code · Computer

P2508 ECM/PCM Power Input Signal High

How urgent? Get it checked in the next few days

What it means

The computer is watching the power supply circuit to the engine computer and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. The engine computer needs a steady supply voltage to run everything else correctly.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring and ground connection for the power supply circuit to the engine computer
  2. Check for wires melted or rubbed together in the harness
  3. Measure the circuit with a meter before replacing parts

Signs you may notice

  • Check engine light on
  • Hard starting or stalling in some cases
  • Other electrical codes may appear

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWeak battery or loose, corroded battery terminals
  • CommonSignal wire shorted to voltage or a broken ground wire
  • CommonFailed engine computer power relay
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Fix the battery, cable or wiring fault first; replace the power relay or fuse if bad. The engine computer itself is rarely the cause.

Walk through it step by step: Check engine light on →

Common questions

What does P2508 mean?

The computer is watching the power supply circuit to the engine computer and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. The engine computer needs a steady supply voltage to run everything else correctly.

Can I drive with code P2508?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2508?

Common possibilities to test include: weak battery or loose, corroded battery terminals; signal wire shorted to voltage or a broken ground wire; failed engine computer power relay; corroded or loose connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.