P2706 Shift Solenoid "F"
What it means
The computer is watching the shift solenoid "F" and has spotted an electrical fault. This solenoid inside the automatic transmission directs fluid to change gears.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Look over the connector and wiring for the shift solenoid "F", checking for damage, corrosion or a loose fit
- Check power, ground and resistance of the part with a meter
- Clear the code and see if it comes back
Signs you may notice
- Check engine or transmission warning light on
- Harsh, late or erratic shifts
- Transmission may go into limp mode (stuck in one gear)
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonUnplugged, loose or corroded connector at the shift solenoid "F"
- CommonBroken or chafed wire in the shift solenoid "F" circuit
- CommonFailed shift solenoid "F"
- PossibleBlown fuse or failed relay feeding the circuit
- PossibleControl module fault (rare)
Typical repair once the cause is confirmed
Repair the wiring or connector if it is damaged; otherwise replace the shift solenoid "F".
Common questions
What does P2706 mean?
The computer is watching the shift solenoid "F" and has spotted an electrical fault. This solenoid inside the automatic transmission directs fluid to change gears.
Can I drive with code P2706?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2706?
Common possibilities to test include: unplugged, loose or corroded connector at the shift solenoid "f"; broken or chafed wire in the shift solenoid "f" circuit; failed shift solenoid "f"; blown fuse or failed relay feeding the circuit. A shop should confirm the cause before replacing parts.